Advertisement
OPERATING THE
BA-VMOUNT
Important
The BA-VMOUNT will operate only with two
14.4-14.8-volt V-mount batteries installed.
Do not attempt to power your Genaray
light using a single V-mount battery.
Slide each battery into the V-mount
until it locks into place.
To remove a battery, press the battery
release and slide it out of the mount.
To attach the BA-VMOUNT to a light stand,
loosen the wing nut, and open the clamp.
Close the clamp around the light stand,
and tighten the wing nut until secure.
POWERING A LIGHT
Important
Do not attempt to power two lights from
the 24 V and 60 V outputs simultaneously.
· Use the 3-pin XLR cable to connect
the 24 V output to your light.
· Use the 5-pin XLR cable to connect
the 60 V output to your light.
To unplug the XLR cable, press the cable
release tab and remove the connector.
Dual V-mount Adapter - USER MANUAL
5
Advertisement
