Beko BSS 4600 TT User Manual page 5

1 Important instructions for safety and environment
In order to prevent the power
•
cable from getting damaged,
make sure that it doesn't get
stuck, twisted or rub against
sharp surfaces. Keep the power
cable away from hot surfaces and
open flame.
Make sure that the power cable
•
doesn't accidentally get unplug-
ged or someone doesn't trip over
the cable during the operation of
the appliance.
If there is a breakdown after using
•
the product, unplug it.
Always unplug the appliance
•
before cleaning and never clean it
while the appliance is being used.
Never operate any part of this
•
appliance on or near hot surfaces
such as gas stoves, electric sto-
ves or heated ovens or place it on
these surfaces.
Never use the appliance at or
•
near the places where there are
explosive or inflammable atmosp-
here or materials.
Water Dispenser / User Manual
The ambient temperature of the
•
room where your water dispen-
ser is placed must be between
10 - 43 ˚C. Operating your water
dispenser under cooler or warmer
conditions is not recommended
with regard to its efficiency.
Leave an open space of minimum
•
15 cm. at the back of the water
dispenser to ensure proper ven-
tilation.
If two water dispensers are to be
•
installed side by side, there sho-
uld be at least 2 cm distance bet-
ween them.
Your water dispenser is supposed
•
to operate and stop without vib-
ration. Make sure that your water
dispenser is balanced on a hori-
zontal and steady surface. This
should be done before the water
bottle is placed.
Your water dispenser is cleaned
•
at the manufacturing plant after
the production. Moreover, the
product is put into service after
being cleaned by our authorized
services with the Special Clea-
ning Agent during the installation.
5 / 14 EN