Advertisement
Quick Links
A Don't place the unit where its exposed to rain, high temperatures, high
humidity, dust, salt spray, or other severe environments.
A Don't press on the LCD display. If broken, use caution not to scratch
yourself.
A Don't press on the Camera Lens or Detector Lens on the Outdoor
Communicator.
A Don't pull excessively on the yellow FPC cable this may damage the FPC
cable causing improper operation and void the warranty.
A Don't use any other charger than the one provided to charge the battery.
A Do refer to the User Manual when you install battery, Micro SD card, FPC
connection, and insert the USB cable.
A Do confirm the door thickness and choose the proper screws to protect the
device from damage.
1 .lfthe screws don't secure the Outdoor Communicator to the
door, confirm the door thickness to verify the proper screws are
used.
2.Afterpressing the
'Previevi
button and the device displays
'Device
Not
Ready
or
'Failure',
it may be caused by the FPC cable not be fully
connected to the Inside Communicator.
3. If
'Please Insert Micro SD
Card appears on the LCD Display
when taking a photo or video. Please remove and re-insert the
Micro SD Card.
4.lf the Monitor LED flashes every 3 seconds it means the
batteries are low. Please change or charge battery.
5.lf the unit continuously alarms with no display, the FPC cable
may be loose. Dis-connect the FPC cable and re-connect
to
ensure the cable is fully seated into the connection.
Installation Instructions
Remove the traditional
peephole viewer or drill a
new hole (recommend hole
size; approx. l3mm)
Rarooethe foam
adhesive on the back of
the outdoor
communicator.
Insert the Outdoor
Communicator and FPC cable
through the peep hole. Use
caution not to fully press the
Outdoor Communicator against
the door.
Before pressing the Outdoor
Communicator against the door,
ensure that the Doorbell is
below the Detector (pictured
above).
Gently insert the FPC
cable through the
rectangle hole in the
Indoor Communicator
mounting bracket.
Secure the mounting
bracket using the proper
screws
Insert the Micro SD card. Be
careful to insert the Micro SD
card in the right direction.
Open the battery cover
(beneath slide cover on top)
and connect the FPC cable.
Be careful to insert the FPC
cable in the right direction.
Install the battery and re-
install the battery cover, Be
careful to insert the battery
the right direction.
Attach the Outdoor
Communicator to the
mounting bracket, Use
caution not to pitch the
FPC cable.
CANNON
SECURITY PRODUCTS
DVOIP
Digital Door Viewer
User Manual
Advertisement
