Advertisement
Operating Instructions
Procedures
• Connect the plug of the laser head to the power supply, and tighten the screw.
• Remove the sticker on the laser head aperture.
• In the power-off state, use the AC input port to connect to the circuit, and load the
Analog Modulation Signal. When connected, the power supply status indicator will
light up (red); approximately 3~5 seconds later, the function status indicator will light
up (green), and the laser will be functional. After 5 minutes under room temperature,
the laser will enter stable operating status.
• When analog connection is needed, please see "Laser Analog Modulation Instruction
Manual"
• After operation, place the sticker back over the aperture, avoiding dust damage.
#
Name
On-off Switch
1
AC input port
2
Laser Head Connection
3
Operation Status Indicator
TTL/Analog Modulation
4
Signal Wires
Phone: +1-647-800-0936; Fax: +1-647-340-7118; http://www.ultralasers.com
1
The power supply and laser head are not commutative and is not
interchangeable. Please ensure they have corresponding serial numbers.
When power supply is on, the red status indictator will be lit; When the
laser is functional, the green status indicator will be lit.
Red is the anode, and the white (or black) is the cathode. 0 – 5 VDC
Ultralasers, Inc
455 Hewitt Circle, Newmarket, ON L3X 2M1 CANADA
2
3
4
Instruction
100 – 240 VAC
Advertisement
