Summary of Contents for G.I.KRAFT GI15111
- Page 1 G.I.KRAFT Instruction Manual GI15111 Our equipment is approved by the following car manufacturers...
-
Page 2: Table Of Contents
Contents 1. Precautions 2. Specifications 3. Installation 4. Controls 5. Operation 6. Troubleshooting 1) Troubleshooting 2) Lamp Tube Replacement 7. Exploded View 8. Circuit Diagram... -
Page 3: Precautions
1. Precaution 1. Read this manual carefully before installing or servicing this equipment. 2. This equipment is designed for paint drying applications. Adjust to the correct temperature and check minimum safe distance from heat source when using. Improper servicing can cause paint surface damage. 3. -
Page 4: Specifications
2. Specifications GI15111 Model Input Power Source Single Phase 220V 50/60Hz Input Power (W) 3 × 1000 Curing Area (mm) 1200 × 1000 Time Setting 0 - 99mins Adjustable Light Intensity (%) 10 - 100 Page 2... -
Page 5: Installation
3. Installation The shortwave infrared curing lamp is divided into 3 parts (a base, a column and a cassette). 1) Installation of the base. a. Open the packing of the base. b. Install the four wheels on the base respectively and tighten up the screws. Usually, the wheels with brakes should be mounted on the rear of the base. -
Page 6: Controls
4. Controls Pull up this handle Pull up this handle to move cassettes to move cassettes up and down. up and down. Pull up this handle Pull up this handle to move cassettes to move cassettes up and down. up and down. Curing time 2. -
Page 7: Operation
5. Operation Connection of electrical supply. Make sure that the supply cable is at least 4mm at 220V. Note: Make sure that the facility supply voltage and frequency are the same as shown on the equipment name plate. Connect to power supply of AC 220V. Switch on the equipment. The LED display will show the normal voltage as 220V. -
Page 8: Troubleshooting
6. Troubleshooting 1. Troubleshooting CAUSE PROBLEM SOLUTION Light tube does not work a. Light tube damaged a. Check light tube b. Lamp is not plugged in b. Check the connections Digital display is blank or a. Unplugged flat wire in a. -
Page 9: Lamp Tube Replacement
6. Troubleshooting 2. Lamp Tube Replacement 1. Prepare cassette for replacement 2. Remove the grille of cassette 3. Remove the plates from both ends of the cassette 4. Remove the fixed plates from both ends of the cassette 5. Remove fixed screws and cut off connections, the lamp can now be replaced 6. -
Page 10: Exploded View
7. Exploded View Name Name Name Name Upright post Connecting axle Base Digital display Top cover Connector (right) Back wheel Plastic band Handle Flange Connector (left) Lower connecting rod Cover plate (lower) Bracket Upper connecting rod Control transformer Clamping bar Lifter Power switch Cassette... -
Page 11: Circuit Diagram
8. Circuit Diagram Page 9...