Advertisement
8
Finishing the Installation
No Parts Required
Procedure
1. Pull up on the seat latch release bar and lower the seat
into the locked position.
2. Attach the negative battery cable to the battery post.
3. Raise the hood until the prop rod can be raised above
the frame tube, then lower the hood. Secure the hood
latches.
Figure 13
1. Seat latch release bar
Operation
The Road Light Kit consists of 2 front mounted head lamps,
2 combination warning/turn/tail lamps and a horn.
Using the Light Switches
Press the front of the light switch
front dipped beam head lights and the rear position lights.
The rear of the switch
(Figure
light.
(Figure
14) to activate the
14) activates the optional work
5
1. Turn signal arm
2. Activates hazard light
3. Activates front dipped
beam head lights and the
rear position lights.
Press the hazard light switch
and rear flashing hazard lights.
Using the Horn Button
Press the horn button to activate the horn
Using the Turn Signal
Press down on the turn signal arm
left turn signal.
Press up on the turn signal arm
right turn signal.
Aiming the Headlights
Use the screws shown in
per local standards.
7
1
2
Figure 14
4. Activates optional
worklight
5. Horn button
(Figure
14) to activate the front
(Figure
(Figure
14) to activate the
(Figure
14) to activate the
Figure 15
to adjust the head lights
3
4
g015907
14).
Advertisement
