Advertisement
Step
7
Connecting the Wiring to
the Sensors and Actuators
Parts needed for this step:
2
Conversion wires (Older boom lifts only)
Procedure
1. Ensure that the wire harness is routed to the
back of the vehicle along the path of the other
wires and hoses.
2. Use cable ties to secure the wiring harness
to the other wiring harnesses away from the
engine and moving parts.
3. Remove the caps on the left and right actuator
connectors of the sonic boom harness. Retain
the caps for later use.
4. Running the T end of the wiring harness along
the center boom frame, connect the wires as
follows:
Note: Older actuators may have a square
connector plug that is different from the
labeled actuator connector on the sonic boom
wire harness. In this case, use the conversion
cables provide in loose parts to make the
connection as instructed.
A. Connect the connector with the red/white
and black/white wires to the connector on
the right boom lift actuator.
B. Connect the connector with the red and
black wires to the connector on the left
boom lift actuator.
C. Connect the connector with the white,
black/blue, and black wires to the right
sensor wire.
D. Connect the connector with the white,
black/orange, and black wires to the left
sensor wire.
5. Use the caps removed previously to cover and
protect the left and right actuator connectors
on the machine harness.
6. Secure the wiring harness to the boom frame
using cable ties as needed.
Step
8
Calibrating the Sonic Booms
No Parts Required
Procedure
1. Park the sprayer in an open, level turf area that
is free of trees, buildings, vehicles, debris, and
underground utilities and plumbing.
2. Set the Sonic Boom switch to the manual
position.
3. Use the left and right boom switches to move
the booms so that they are parallel with the
ground.
4. Set the Sonic Boom switch to the Off position.
5.
A. Press and hold the left boom switch in the
Lower position and the right boom switch
in the Raise position.
B. While holding the switches, set the Sonic
Boom switch to the Automatic position.
Note: The Sonic Boom light flashes rapidly,
indicating calibration mode.
6. Release the boom switch.
7. Use the boom switches to adjust the booms
if necessary so that they are parallel to the
ground.
You will have 20 seconds to adjust the booms.
At the end of 20 seconds the light stops
flashing and the Sonic Boom calibration is
complete.
13
Advertisement
