Advertisement
Locate the dimples in the factory plastics and drill with a 1/4"
drill bit and after with the 2 " hole saw.
Locate the factory dimples
Place and align the rockslider on the 2" perforations that were
made.
Align
Align
Align
Use a 3/8 x 2 1/2" screw and place from the back, starting from
3
the front and rear perforation. (Do not tighten yet)
Rear Tube with 3/8 x 2 1/2" Screw
4
Place the central screw and torwue bearsto 35lb ft.
Frontal Tube with 3/8 x 2 1/2" screw.
Frontal Tube with
3/8 x 2 1/2" Screw
Advertisement
