Vizio RP56 User Manual page 53

Symptom
The LED on the Universal Remote
Control does not blink when a
button is pressed.
The Universal Remote Control LED
blinks when a component selection
button
component does not respond.
The Universal Remote Control will
not accept the component program
code.
The Universal Remote Control
does
entertainment
commands
properly.
TV/VCR Combo does not respond
to the Universal Remote Control
properly.
No volume on a 2nd TV.
Changing channels does not work
properly with the Universal Remote
Control.
The PIP Remote Control does not
work.
040330
is pressed, but the
not control home
components
are not working
Possible Solutions
Replace the batteries with two (2) new alkaline batteries.
See "Inserting batteries" on page 11.
Make sure that you are less than 15 feet (4.5 meters) from
the infrared remote sensors on the component.
Make sure that nothing is blocking the infrared remote
sensors on the remote control or the component.
Make sure that you have chosen the correct component
selection button.
Make sure that the remote is programmed for that
component. See "Programming the Universal Remote
Control" on pager 34.
Check that the component's original remote control will
operate the component.
Make sure that you followed all the steps in the
programming procedure. See "Programming the Universal
Remote Control" on pager 34.
Make sure that you tried all the program codes listed for the
component manufacturer. See Appendix B – Component
Program Codes" on page 54.
Search for the component code.
Component Codes" on pager 34.
Try all listed codes for the component brands being set up.
Make sure they can be operated with an infrared remote
or control.
Use the VCR codes for your brand. Some combo units
may require both a TV code and a VCR code for full
operation.
Follow instructions for "Changing Volume Lock", see page
36.
If original remote control required change channels does
not work properly, press ENTER on the universal remote
after entering the channel number.
Check if the Remote Control batteries are dead and if
necessary, replace them with new batteries.
Make sure that nothing is blocking the infrared remote
sensors on the remote control or the DLP TV.
50
VIZIO RP56 User Guide
See "Searching for