Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for CML Top Gun Heli-Flite Orbiter
-
Page 2: Table Of Contents
Orbiter & Vortex RTF MICRO-COPTERS CONTENTS: SECTION 1: KIT CONTENTS AND DESCRIPTION PAGE 4 SECTION 2: BATTERY AND CHARGER PAGE 6 SECTION 3: TRANSMITTER PAGE 7 SECTION 4: FINAL SET UP PAGE 8 SECTION 5: ADJUSTMENTS & MAINTENANCE PAGE 9 SECTION 6: TESTING &... - Page 3 INSTRUCTION MANUAL CONGRATULATIONS ON PURCHASING THE ORBITER OR VORTEX RTF HELICOPTER Top Gun Park-Flite are proud to present this high performance model helicopter for your enjoyment. With its co-axial contra rotating rotor system, twin motors and complex electronics, this model provides the enthusiast with an easy to fly fully functional helicopter for indoor and outdoor use.
-
Page 4: Kit Contents And Description
SECTION 1: KIT CONTENTS AND DESCRIPTION Fuselage with all components installed and LiPo Battery 2 cell 7.4V 800 mAh (10c). connected: twin 140 size motors, 3 in 1 Gyro- Electronic Speed Control (ESC) and mixer, 4 LiPo charger (2 cell 7.4V 0.6Amps). channel receiver, two quantity servo, pushrods and linkages. - Page 5 FUSELAGE ASSEMBLY. Supplied complete and ready for use. Twin 140 motors installed and connected to Electronic Speed Control (ESC), 35mhz receiver, aileron and elevator servos connected to swash plate with ball link type push rods. BATTERY, CHARGER AND MAINS ADAPTOR. 7.4V (2 cell) 800 mAh LiPo battery rated at 10C max discharge.
-
Page 6: Battery And Charger
SECTION 2: BATTERY AND CHARGER WARNING A lithium polymer (LiPo) battery rated at 10C and charger is included as part of this package and these cells must be operated with care to prevent the risk of fire. LiPo Batteries are soft cased and can be easily damaged by sharp items, puncturing of the soft casing can cause fires and we recommend that they are stored and handled carefully. -
Page 7: Transmitter
SECTION 3: TRANSMITTER Frequency control is by removable crystal. The transmitter frequency is identified on the crystal holder located at the rear of the transmitter. 8 off AA size dry cells or high capacity NiMh batteries must be inserted before operation. Remove the rear cover and install batteries into the battery tray as directed by the moulded in polarity (+ &... -
Page 8: Final Set Up
SECTION 4: FINAL SET UP INSTALL THE CHARGED LIPO BATTERY INTO THE FUSELAGE. It locates in a cradle positioned at the bottom of the chassis. The receiver aerial is supplied coiled up around the skid type undercarriage. It’s position should be adjusted to give correct balance. -
Page 9: Adjustments & Maintenance
WARNING With the battery connected and the model switched on the motors are now live. The Electronic Speed Controller (ESC) will go through it’s start up procedure and will emit a series of beeps while it configures throttle positions. The motor could start unexpectedly and we recommend that the model is restrained and that the operator keeps clear of the rotors during... -
Page 10: Testing & Adjusting Aileron And Elevator Control
SECTION 5: ADJUSTMENTS & MAINTENANCE – CONTINUED SECTION 6: TESTING AND ADJUSTING AILERON AND ELEVATOR CONTROL Always make small corrections to the controls. Do not move sticks too far or you may overcorrect. -
Page 11: Basic Control For The Vortex/Orbiter Helicopter
SECTION 7: BASIC CONTROLS FOR THE VORTEX/ORBITER R/C HELICOPTER Always make small corrections to the controls. Do not move sticks too far or you may overcorrect. -
Page 12: First Flight
SECTION 7: BASIC CONTROLS FOR THE VORTEX/ORBITER R/C HELICOPTER – CONTINUED Always make small corrections to the controls. Do not move sticks too far or you may overcorrect. SECTION 8: FIRST FLIGHT... - Page 13 Always make small corrections to the controls. Do not move sticks too far or you may overcorrect.
-
Page 14: Safety Information
CML Distribution can supply suitable simulators. The supplied transmitter includes a trainer jack socket to allow connection using an adaptor lead to your computer. - Page 15 IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS – READ BEFORE USE • Lithium Polymer batteries can be volatile. Whilst some of the instances listed below are rare, they can occur and it is important for you to be aware of how to handle such situations. Failure to read and follow the below instructions may result in fire, personal injury and damage to property if charged or used improperly.
-
Page 16: Section 10: Spare Parts Listing
SECTION 10: VORTEX/ORBITER R/C HELICOPTER SPARE PARTS LISTING MAIN BLADE TGP0610 FLYBAR SET TGP0611 INNER SHAFT TGP012 OUT SHAFT AND GEAR SET TGP0613 MAIN FRAME TGP0614 MAIN BLADE GRIP SET TGP0615 GEAR SHAFT SET TGP0616 SWASHPLATE SET TGP0617 ROTOR HEAD TGP0618 BATTERY SUPPORT TGP0619 LANDING SKID TGP0620 (Orbiter) SHAFT RETAINING TGP0622... - Page 17 BROOM BRACKET TGP0631 INNER BLADE TGP0633 TAIL BOOM TGP0630 TAIL BOOM BRACES TGP0632 TAIL ROTOR & FIN TGP0634 VORTEX CANOPY TGP0637B TGP0637Y SPARE PARTS LISTING TGP0610 Orbiter/Vortex Main blade (4pcs) TGP0635R Orbiter front body (Red) TGP0611 Orbiter/Vortex flybar set TGP0636R Orbiter rear body(Red) TGP0612 Orbiter/Vortex inner shaft TGP0635Y...
-
Page 18: Notes
NOTES:... - Page 20 DISTRIBUTORS OF QUALITY MODEL & HOBBY PRODUCTS Saxon House, Saxon Business Park, Hanbury Road, Bromsgrove, Worcestershire. B60 4AD. England Tel: +44 (0) 1527 575349 Fax: + 44 (0) 1527 570536 E-mail: info@cmldistribution.co.uk Web site: www.cmldistribution.co.uk...
Need help?
Do you have a question about the Top Gun Heli-Flite Orbiter and is the answer not in the manual?
Questions and answers