Table of Contents
Advertisement
Quick Links
P L E A S E R E A D C O M P L E T E L Y B E F O R E Y O U B E G I N A S S E M B L Y
Win FREE Arboria Products
Win FREE Arboria Products
Win FREE Arboria Products
Win FREE Arboria Products
Give us feedback about this Arboria product and be entered into a drawing to win Arboria goods. It's easy, go to
www.Arboria.com, choose a product then click on the link to review
that we may contact you if you win. Upload a photograph for an extra chance to win.
cial rules. No purchase necessary.
CHECK BOX FOR THESE CONTENTS
Trellis Caps (7)
1
Headers (2)
2
Braces (4)
3
Lattice Side Panels (2)
4
T O O L S Y O U W I L L N E E D
Power screwdriver or drill that accepts interchangeable
•
bits*
Two bags of concrete mix (60#) to anchor the arbor
•
A bit holder may be needed if using a drill with a quick-change chuck.
*
HANDY TO HAVE
Tape measure
•
Carpenters Square
•
Stool or short ladder
•
P R E L I M I N A R I E S
IF YOU PLAN TO
If you wish to stain or paint your arbor, we recommend that you do so before assembly, it makes the job eas-
ier. Use a high quality exterior stain or paint. Be careful not to cover up guide marks on top of headers.
WORK AREA
Select an area close to where the arbor will be finally placed. While the assembled unit is not very heavy, it is
awkward to move far and requires two people to do so easily.
The assembly area should be relatively flat and open, at least 8' square. A lawn, driveway or wide path will be
satisfactory.
It is a good idea to lay out the arbor box on your work surface to protect the arbor from nicks and scratches.
A S S E M B L Y I N S T R U C T I O N S
Rosedale Arbor
Upload a photograph for an extra chance to win.
Upload a photograph for an extra chance to win.
Upload a photograph for an extra chance to win.
HARDWARE
- 2 1/2" Wood screws (30)
- Driver bit
(if other than Phillips head)
- Wood block marked "spacer" (1)
- Anchoring kit
review
review. Be sure to enter your email and telephone so
review
1
4
2 2 2 2
Visit www.Arboria.com for offi-
2
3
445.35.98
4/27/2007
Advertisement
Table of Contents
Summary of Contents for Arboria Rosedale Arbor
- Page 1 Win FREE Arboria Products Win FREE Arboria Products Give us feedback about this Arboria product and be entered into a drawing to win Arboria goods. It’s easy, go to www.Arboria.com, choose a product then click on the link to review...
- Page 2 A T T A C H I N G T H E H E A D E R S T O T H E S I D E P A N E L S Pilot holes STEP 1 Lay one of the 2” x 6” header boards flat on your work sur- face, with the 12 small pilot holes facing up and the shorter side toward you.
- Page 3 S Q U A R E U P T H E A R B O R STEP 3 Now square up the arbor. This can be easily done with a large Carpenter’s Square, a tape measure, or even a length of string as shown below.
- Page 4 A T T A C H T H E C A P P I E C E S STEP 5 Center one of the cap pieces across the two headers, placing it between the two marks. Center one screw hole on top edge of header. Secure cap to second header in same manner.
Need help?
Do you have a question about the Rosedale Arbor and is the answer not in the manual?
Questions and answers