velda T-Flow Tronic Series User Instructions

velda T-Flow Tronic Series User Instructions

Advertisement

Downloaded from www.watergardeningdirect.com
GEBRAUCHSANWEISUNG T-FLOW TRONIC
MODE D'EMPLOI DU T-FLOW TRONIC
USER INSTRUCTIONS T-FLOW TRONIC
ИНСТРУКЦИЯ ПО ПРИМЕНЕНИЮ T-FLOW TRONIC
brings life to your pond

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T-Flow Tronic Series and is the answer not in the manual?

Questions and answers

Alan Prescott
March 13, 2025

Have you got a free Video that showed how to install the T flow tronic

Summary of Contents for velda T-Flow Tronic Series

  • Page 1 Downloaded from www.watergardeningdirect.com GEBRAUCHSANWEISUNG T-FLOW TRONIC MODE D'EMPLOI DU T-FLOW TRONIC USER INSTRUCTIONS T-FLOW TRONIC ИНСТРУКЦИЯ ПО ПРИМЕНЕНИЮ T-FLOW TRONIC brings life to your pond...
  • Page 2: Service Parts

    Downloaded from www.watergardeningdirect.com for T-Flow Tronic Art. nr. SERVICE PARTS Anode for T-Flow 05 126685 Anode for T-Flow 15 126690 Anode for T-Flow 35 126695 Anode for T-Flow 75 126700 for T-Flow 05/15 126716 Cathode Cathode for T-Flow 35/75 126717 End cap &...
  • Page 3 The core of the T-Flow consists of an anode (1), made from a mineral copper alloy developed by Velda, and a stainless steel cathode (2). By means of the microprocessor controlled display unit (5), pulses are generated, which are led to the core of the T-Flow.
  • Page 4: Installation

    Downloaded from www.watergardeningdirect.com INSTALLATION l The housing contains the copper anode and the stainless steel cathode, which together form the core of the T-Flow Tronic. Unscrew the end cap (3), tighten the anode (1) and place the cathode (2) over it. The water flow brings the copper ions in the pond water.
  • Page 5: Storage And Cleaning

    Downloaded from www.watergardeningdirect.com Temperature sensor The temperature sensor will calibrate first and after about 15 minutes it will indicate the right temperature. At water temperatures below 12°C the system will shut down automatically. The settings are preserved and above 12°C the device will switch on again.
  • Page 6 4. replace copper anode: the diameter of the copper anode has strongly reduced. Solution: Replace the copper anode (1). 5. see manual (velda.com) Solution: When these mea- sures have no effect and the message ERROR 1 remains displayed, visit www.velda.com/service for assistance.
  • Page 7 However, as the envi- ronment and composition of pond water will differ from pond to pond, Velda can not exclude death of fish for 100%, also in case the T-Flow Tronic is used.
  • Page 8 Downloaded from www.watergardeningdirect.com T-Flow Tronic online GAW126651015 Design, Research & Development Velda® The Netherlands www.velda.com info@velda.com brings life to your pond...

This manual is also suitable for:

T-flow tronic 05T-flow tronic 15T-flow tronic 35T-flow tronic 75T-flow tronicT-flow 05 ... Show all

Table of Contents