1. Manuals
  2. Brands
  3. RTS Manuals
  4. Conference System
  5. KP 12 CLD
  6. Installation instructions

RTS KP 12 CLD Installation Instructions

Gpio option expansion unit
Hide thumbs
1
2

Advertisement

Table of Contents

KP 12 CLD GPIO Option Expansion Unit
IMPORTANT:
To install the KP 12 CLD GPIO Expansion Panel, do the following:
On the rear of the KP 12 CLD, remove the two (2) hex screws on either side of the DB-9 connector.
1.
Align the mounting tab located on the front of the KP 12 CLD GPIO expansion unit with the mounting tab slot located on
2.
the rear of the KP 12 CLD unit. See Figure 1.
IMPORTANT: Do not attach the GPIO expansion unit mounting tab to the KP 12 CLD unit. Attaching the unit with this one
F.01U.196.235 Rev 04
Installation Instructions
Once you have finished installing the GPIO Expansion Unit, you must perform a Reset Cfg on the unit.
(1) screw may cause the chassis to bend or be damaged. Continue to step 2.
GPIO Expansion Unit — Mounting Tab Alignment with KP 12 CLD
FIGURE 1.
06/2012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KP 12 CLD and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for RTS KP 12 CLD

  • Page 1 On the rear of the KP 12 CLD, remove the two (2) hex screws on either side of the DB-9 connector. Align the mounting tab located on the front of the KP 12 CLD GPIO expansion unit with the mounting tab slot located on the rear of the KP 12 CLD unit.
  • Page 2 Using the screws provided, attach the GPIO Expansion Unit to the rear panel of the KP 12 CLD unit (see Figure 2). GPIO Expansion Unit — Attachment Points FIGURE 2. Using the screw provided, attach the mounting tab to the mounting tab slot. See Figure 3.

Table of Contents