Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Roof Tech APEX
- Page 1 RT-APEX installation guide ------2019JUL31 ver.1---- ROOF TECH INC. RT-APEX INSTALLATION GUIDE...
- Page 2 APEX Base installation Y0: 3/16” from upper shingle Y1: 4 1/8” from Y0 “R” logo left top indicates the Ridge side Y1-Y: PV Width+1 1/16” (Landscape) when installing the base. Y1-Y: PV Length + 1 1/16” (Portrait) 5 Screws 2 Screws...
- Page 3 APEX Clamp location End Clamp Middle Clamp Note: To fix the modules on the ridge side. The End clamp must be removed and rotated 180 degree also switch the M10 hole. ＊Bottom clamp stay same direction ONLY End Clamp need to be...
- Page 4 APEX Splice location End Splice Middle Splice Note; End Splice must be untighten and twist 180 degree to fix panels on ridge side. ＊Bottom clamp stay same direction ONLY End Splice need to be switched...
- Page 5 APEX First row installation Important Step for a Smooth Skirt set up. First row alignment Use strings to align the first row, and set the bottom side socket head cap screw. *Place End clamp or End Splice to the base.
- Page 6 APEX SKIRT & First Row Installation RT-APEX End Clamp ・32-40 mm frame height ・Universal End clamp ・up to 1 9/32” leveling ・Integrated cable holder tray Skirt installation steps At End clamp location Slide in skirt to End clamp Place skirt all the way in...
- Page 7 APEX SKIRT & First Row Installation RT-APEX End Splice ・32-40 mm frame height ・Universal End clamp ・up to 1 9/32” leveling ・Integrated cable holder tray Skirt & Splice installation note End Splice clamp shall be set with PV panels at the same time,.
- Page 8 APEX Second & Middle Row Installation First row installation RT-APEX Middle Clamp ・32-40 mm frame height ・Universal End clamp ・up to 1 9/32” leveling ・Integrated cable holder tray Middle clamp installation IMPORTANT!! Set the middle clamp flush with the Torque the middle clamp PV Panel frame.
- Page 9 APEX End Row Installation IMPORTANT!! At the ridge side or top row, the end clamp must be fully untightened and rotated 180 degrees. The bottom bracket and pillar are installed same as the others. End clamp installation Height adjustment shall be done after panels are fixed.
Need help?
Do you have a question about the APEX and is the answer not in the manual?
Questions and answers