Summary of Contents for DRI Heat Elite 8
- Page 1 Elite 8 Heater “For Professional use only” Operations Manual EPA EST. No. 086342-AZ-001 DRI Heat 877-432-8601 Fax: 215-586-2405...
- Page 2 Always wear rubber gloves and boots when operating the Elite 8 in damp conditions. Never operate the Elite 8 unless all panels and guards are in place and properly secured. Always keep the air inlet & outlet clear of any obstructions and loose material.
- Page 3 1 year on parts and labor Warranty Coverage: K & J Representatives, LLC warrants that, for one (1) year, the Elite 8 manufactured by K & J Representatives, LLC will operate free from defects in material or workmanship, or K & J Representatives, LLC, at its option, will repair or replace the defective part(s), free of charge.
- Page 4 602-723-2534. Your Elite 8 has Eight (8) 120volt plug-ins for the heat elements located three (4) on each side of the Elite 8. Each heating element is 8 amps or 960 watts. Two (2) heating elements can be plugged into a 20 amp circuit. With (4) 20 amp circuits Please Note: Push all plugs into the sockets on the heater until they you can achieve full power of your Elite 8.
- Page 5 Best Practices for Heating rooms 1. Heat rises. Always try to seal the room(s) from escaping heat. Especially HVAC vents, bathroom exhaust fans, bottoms of doors, wall air-conditioners, etc… Cover windows pane with blankets or equivalent to minimize loss of energy from cold windows. 2.
Need help?
Do you have a question about the Elite 8 and is the answer not in the manual?
Questions and answers