Related Manuals for SENAO SP-428
Summary of Contents for SENAO SP-428
- Page 1 Email: senao@senao.ru harvest@harvest.ru Web : http://senao.ru http://harvest.ru Installation Guide SP-428 1/13...
- Page 2 Indoor performance Open space 30~50M 30~50M 30~50M Through Concrete wall 20~30M 20~30M 20~30M 2/13...
- Page 3 Upstairs & Downstairs 10~20M 10~20M 10~20M 10~20M 10~20M Glass Door & wood Partition-Board will minor affect the communication range. Glass door Wood Partition-Board The range performance of Central Unit、Remote Base Station & Repeater are the same. 3/13...
-
Page 4: Antenna Pattern
Antenna pattern Antenna pattern is omni and horizontal. 4/13... - Page 5 Antenna with vertical installation will has better range performance in horizontal direction. Antenna with horizontal installation will has better range performance in vertical direction. Setup at higher location for better range cover performance. 5/13...
- Page 6 Installation Guide for Central Unit Don’t set up the Central Unit at corner of wall that will reduce the communication range. Don’t set up the Central Unit on the building center pillar that will reduce the communication cover range on the pillar back area. 6/13...
- Page 7 Don’t set up the Central Unit at the low location, the communication cover range will be poor and signal is easy to be interrupted. Central Unit be installed as high as possible inside the building and avoiding the obstacle wall and pillar, don’t just to fit the near by phone jack or AC plug and install it in the power room or switching room.
- Page 8 遠端機地台與中繼器安裝指南 / Installation Guide for Remote Base Station & Repeater Use the twisted pair cable (AWG-24) within 1000Meters to connect Central Unit and Remote Base Station. Twisted pair cable longest 1000meters Remote base station can be plugged to Central Unit, no require to register with Central Unit.
- Page 9 2. If NO DC 48V output ,please check the cable even broken or DECT module NO DC 48V output。 3. If the cable have DC 48V output ,but remote bast station of red color LED NO flash ,please send the RBU to SENAO repair center 。 9/13...
- Page 10 OFF ,please power ON and OFF again . After 1~2 minute later , if LED still not flash as one second ON and one second OFF state, please send the Remote base unit to SENAO repair center。 The Repeater LED will in slower flash mode, when it is in the standby mode.
- Page 11 Don’t set up the Remote base station and Repeater at corner of wall that will reduce the communication range. Don’t set up the Remote base station and Repeater on the , the back area of beam will be very poor in communication range. beam If Remote base station and Repeater set up on the beam, the antenna 11/13...
- Page 12 should appear out side of the beam to get more range. Remote base station and Repeater be installed within the good signal strength area for each other, try your best to a avoid the obstacles like wall or beam in between Remote base station and Repeater. Beam Wall 12/13...
- Page 13 SP-428 Repeater setting & troubleshooting Setting procedure for SP-428 repeater: 1.Hold the register switch of central unit (CU) around seconds until the orange color LED which in the left side of CU changing to fast flashing mode。 2.Holding the register switch of repeater around...