Quax SUNNY 54 01 45 Series Manual page 33

SUNNY
54 01 45xx
Step 3 : Use the parts of steps 1 and 2, a side 2, two short wood screws B, two long wood screws C, four
wooden dowels A, the Allen key SW4 and four gliders K
Push two wooden dowels (A) into the drillings on the ends of the side (2). Hold the side with its drillings
in front of the openings of a leg frame (1). Push two short wood screws (B) into the upper drillings of the
side frame and tighten them slightly with the wrench (SW4). Push two long wood screws (C) into the lower
drillings of the side frame and tighten them slightly. Push the longeron (4) with its wooden dowels into the
drillings and over the connector of the end panel. Tighten the eccentric. Now position the other leg frame
and repeat the action. Stick two furniture glides (K) at the bottom of the head and foot ends.
Step 4 : Use the parts of step 3, the bottom 3, six bottom supports E and six bolts D
Push the bottom supports (E) with their pin into the drillings on the side (2) and the longeron (4). Make
sure that all bottom supports are positioned at the same height in the lowest position (Z). Insert the bolts
(D) through the drillings in the bottom and tighten into their supports. Tighten all wood screw (B and C)
connections fi rmly.
Omvormbaar bed 120x60 cm
Konvertierbar Bett 120x60 cm
Lit convertible 120x60 cm
Convertible bed 120x60 cm
Quax
First dreams
®
First steps
33