Toshiba TA-FVW100 Instruction Manual page 10

How to use the iron
1
Temperature settings
Press the SET / OFF button to set the temperature according to the fabric you are ironing.
The temperature lamp flashes.
(See page 7)
Attention
If you are ironing a blended fiber, set the temperature according to the lower temperature fiber.
z z
2
Getting started
You can use the iron when the temperature lamp stops
(When you take the iron off the stand, the temperature lamp turns off.)
Put the Steam / Dry lever in the [
z z
Notice
When you first turn on the power, the iron may emit a slight smell and some smoke, but this will go away as you use it.
z z
The iron may not slide well when you iron wet clothes.
z z
How to use the mist spray (FVW100 only)
The droplets of water in the mist are larger than in the steam, so the mist remains on the clothes and you can remove
stubborn wrinkles.
Use mist spray on cotton, linen, and similar fibers.
Press the mist button marked with
Attention
The first time you press the button, the mist may not come out. Press the mist
z z
button several times.
Do not press the mist button
z z
it will come out in big drops.
Water that is left in the mist shot pipe may drip out of the mist outlet while you
z z
are ironing.
If this happens, hold the iron upside down and press the mist button
z z
times to clear the water from the mist outlet before you use the iron.
According to fabric
flashing
and stays
Dry] position.
Flashing
lit
Stays when it reaches the set temperature.
to spray out a mist, then iron the clothes.
slowly. If you do so, the water will not mist and
10
Dry ironing
lit
.
Lighting
several