Advertisement
Quick Links
Advertisement
Summary of Contents for Dwyer Instruments LOVE CONTROLS DIVISION Iso Verter II 4380
- Page 1 Artisan Technology Group is your source new and certified-used/pre-owned equip • FAST SHIPPING AND SERVICE CENTER REPAIRS WE BUY USED E DELIVERY Experienced engineers and technicians on staff Sell your exce at our full-service, in-house repair center We also offer •...
- Page 2 For REVERSE ACTING inputs wire the positive input lead to terminal six and the negative lead to terminal five. Figure 2: Wiring socket LOVE CONTROLS DIVISION Phone: 219/879-8000 DWYER INSTRUMENTS, INC. www.love-controls.com P.O. BOX 373 • MICHIGAN CITY, Fax: 219/872-9057 INDIANA 46360, U.S.A.
- Page 3 Input Programming The input selection and ranging is performed through two switch banks. Refer to the instructions below and the illustration in Figure 3 for details. MODE SELECT SWITCH BANK 1. For CURRENT INPUT turn switch one ON. For VOLTAGE INPUT turn switch one OFF. 2. For UNI-POLAR INPUT (low end of scale ≥ zero) turn switch two ON and turn switch three OFF. 3.
- Page 4 Output Programming The output selection and ranging is performed through two switch banks. Refer to the instructions below and the illustration in Figure 4 for details. MODE SELECT SWITCH BANK 1. For VOLTAGE OUTPUT turn switches one and two ON and turn switch three OFF. 2.
- Page 5 Maximum Current Output Load: 600 ohms. Maximum Voltage Output Load: 20 mA (500 ohms). Input Impedence – Current: 10 ohms. Input Impedence – Voltage: 1 Megohm. ©Copyright 2013 Dwyer Instruments, Inc. Printed in U.S.A. 8/13 FR# 949-0513 Rev. 4 LOVE CONTROLS DIVISION Phone: 219/879-8000 DWYER INSTRUMENTS, INC.
- Page 6 Artisan Technology Group is your source new and certified-used/pre-owned equip • FAST SHIPPING AND SERVICE CENTER REPAIRS WE BUY USED E DELIVERY Experienced engineers and technicians on staff Sell your exce at our full-service, in-house repair center We also offer •...
Need help?
Do you have a question about the LOVE CONTROLS DIVISION Iso Verter II 4380 and is the answer not in the manual?
Questions and answers