ICD Design, LLC is not responsible for any damage that may occur during installation.
This is a general assembly manual and may vary by the Gladiator's versions and options. Please consult our technical department for more information and
assistance.
This manual is for the Jeep Gladiator with and without the factory sliding bed rail. It contains all the hardware for a no drill and drilling applications.
Summary of Contents for ICD DESIGN HOBBS FREEDOM LD48
Page 1
2020 Jeep Gladiator JT ICD Design, LLC is not responsible for any damage that may occur during installation. This is a general assembly manual and may vary by the Gladiator’s versions and options. Please consult our technical department for more information and assistance.
Page 2
ASSEMBLY • Start to assemble the Sport Rack with all the 32- 3/8” bolts, nut and washers included. There are two racks in the kit. • Assemble as shown in the above diagram. • Align the two square holes of each side of the Base Leg to the two slotted lateral holes of the Cross Lateral Bar.
Page 3
• Mounting Option #1: No Drill Installation with Factory Bed Rail System 1. Slide in the mount plate bracket with two bolts into the factory rail system (you will need to remove the end caps to install this plate. 2. Line up the mount plate with the Base Legs and install the 3/8”-16 lock nuts and washers.
Page 4
On a regular basis and especially if you do a lot of off-roading, inspect and tighten any loose bolts. For Technical Support, please call (702) 560-2451 or email: info@icddsign.com HOBBS is a brand of ICD DESIGN, LLC. 2620 Regatta Drive, Suite 102, Las Vegas, Nevada 89128, USA Tel: (702) 560-2451 Email: info@icddesign.com Website: www.icddesign.com...