Advertisement
Quick Links
MM8
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
Do not unpack any contents until you verify all requirements on PAGE 3.
If you have any questions, visit MantelMount.com or call
!
WARNING!
This product contains small parts that can be a
choking hazard. Do not let children play with any of
these small parts! Keep children away from the work
area during installation.
!
WARNING!
Do not let children operate, pull on, or hang from
MantelMount.
Do not operate MantelMount when anyone is near or
behind the mount. MantelMount is very strong and can
result in crushing injuries.
!
WARNING!
MantelMount must be installed to a wall or structure
that is able to hold five times the combined weight of
all equipment. If you are unsure about your structure,
a contractor must evaluate your installation.
!
WARNING!
Exceeding the weight capacity can result in
serious personal injury or damage to equipment!
The combined weight of all components must not
exceed 125 lbs (57 kg).
IMPORTANT:
MantelMount has three different adjustments
that must be made after the installation is
complete in order to operate properly.
The side-to-side swivel stops are
adjusted with two screws and
locknuts so that the TV does not
swivel into the mantel.
Tilt is removed with one screw
inside the swivel mechanism. The
TV should always be vertically
parallel to the wall
The bottom travel stop is adjusted
with two screws and locknuts so
the TV and mount do not lower all
the way into the mantel.
MantelMount MM8
Installation Instructions
Please read this entire manual before you begin.
www.MantelMount.com
(800) 897-9755.
!
CAUTION:
This product is intended to be installed by
professional installation contractors, or persons
familiar with the tools and methods required for
this installation. If you are not sure about your
ability to perform this installation, you must
contact a professional. MantelMount is not
responsible for damage or injury caused by
incorrect installation or improper use.
!
CAUTION:
Do not use this product in any way, or for any
purpose, that is not specifically described in these
instructions. MantelMount is not responsible for
damage or injury caused by incorrect installation
or improper use.
U.S. Pat. No. 8,864,092
PAGE 1
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for MantelMount MM855
- Page 1 IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS Please read this entire manual before you begin. Do not unpack any contents until you verify all requirements on PAGE 3. If you have any questions, visit MantelMount.com or call (800) 897-9755. WARNING!
-
Page 2: Required Tools
Before you begin, please verify that all components are included and undamaged. If any parts are missing or damaged, contact MantelMount. Never proceed with missing or damaged parts! Lay out all components and make sure you identify that each one has a match in the diagram. - Page 3 Please verify that your installation meets all of these CRITICAL requirements: MantelMount is designed for use only with decorative Wall must be WOOD STUD FRAME only. There must be at fireplaces that are not the primary heat source for a least 2 studs available for mounting.
- Page 4 {10} additional clearance for downward motion stated in the chart in Step 9 {12} {08} {11} {07} {11} 6 INCHES 7.5 INCHES to housing to Flange edge {12} {12} or cutout {12} {09} {11} PAGE 4 MantelMount MM8...
- Page 5 Write down this distance to use in Step 9. Screws {19} and Nuts {16}. {18} {29} Bottom of Bottom of Vertical Brace Vertical Brace {16} Bottom of TV {19} Bottom of Sound Bar Use this distance in Step 9 MantelMount MM8 PAGE 5...
- Page 6 (with or without soundbar) see: Step 8 The result will be the correct height above the mantel to install the Housing ADD THIS CLEARANCE FROM THE CHART USE THIS DISTANCE for Step 12 M A N T E L PAGE 6 MantelMount MM8...
- Page 7 Also see STEP 24: battery, as shown. d. Have a pointy device ready such as a pen or paper clip. e. Plug MantelMount into a wall outlet and within 5 seconds Down Button: press the P2 button. The remote is now paired.
- Page 8 Contact MantelMount for more information. If the TV is plugged into the socket located onboard the MM800 instead of a wall outlet, MantelMount can monitor the power to the TV and determine when it is turned on or off. If this feature is not desired, simply plug the TV into a wall outlet and operate the MM800 with the Remote Control.
-
Page 9: Installation Options
Lag Bolts through the holes in the front flange of the Lift Housing {30}. Any studs that were cut can be reattached to the new sections of 2x4. {20} {17} {13} {11} {13} {11} MantelMount MM8 PAGE 9... -
Page 10: Crush Hazard
Step 9. Use a level to ensure the cutout is plumb. NON-RECESSED: Use the Cardboard Template to mark the location of the Housing. MantelMount is located in the DOWN Button: same spot for all installations. - Page 11 Swivel Bracket to increase the thread length. Return to Step 18 for other side. Proceed to Step 19 to set the Soft Stop. Tighten both locknuts after the adjustments are made. Repeat for other side. MantelMount MM8 PAGE 11...
- Page 12 “M2” button. CAUTION: Auto Raising Heat Monitor (ARHM): Never allow children to play around, hang from, This unique safety feature of the MantelMount MM8 will or operate MantelMount. Property damage or monitor the temperature above your fireplace at all times and personal injury can occur.
- Page 13 Ensure that cables do not get pulled or pinched between brackets access holes in the Housing for the cable when the mount is raised. depending on the type of installation. Rear Access for Hard-Wiring Ethernet Port Lower hole through Access Cover Rear Access for Hard-Wiring MantelMount MM8 PAGE 13...
- Page 14 PAGE 14 MantelMount MM8...
- Page 15 MantelMount MM8 PAGE 15...
- Page 16 Monitors the temperature and raises Full Manufacturer Warranty: the TV automatically if the temp. behind the TV is above 130°F MantelMount will replace or repair any product or part that proves defective due to improper workmanship Patent Pending or material during the warranty period.
Need help?
Do you have a question about the MM855 and is the answer not in the manual?
Questions and answers