Advertisement
MAINTENANCE AND CLEANING
Before cleaning, disconnect the power cord of the device from electrical circuit.
Always make sure to fill the activated carbon compartment completely but not
over the edge of the device. Failing to do so can cause the bottom not to close
properly and thus affect the device performance.
Use only activated carbon recommended by the manufacturer.
Unplug the odour neutraliser from electrical circuit. Carefully turn the device around
and place it on soft ground upside down. Unscrew 4 screws on the bottom of the
device and remove the bottom.
Carefully turn the device around and shake activated carbon into prepared box. In
the case of activated carbon cleaning, shake the box for some time so the dust and
other pieces of dirt will fall to the bottom of the box. The activated carbon can be put
in the sun for 4 -6 hours. In this process, the carbon regains its capacity to absorb
various substances from the air. In the case of replacing the activated carbon, throw
the spent activated carbon in the thrash.
Advertisement
Table of Contents
Summary of Contents for 420 Purifier 420 Purifier
- Page 1 MAINTENANCE AND CLEANING Before cleaning, disconnect the power cord of the device from electrical circuit. Always make sure to fill the activated carbon compartment completely but not over the edge of the device. Failing to do so can cause the bottom not to close properly and thus affect the device performance.
- Page 2 Cover the device so that only the chamber for activated carbon remains open. Cut the bag of activated carbon as shown in the figure. Gradually fill the chamber with activated carbon, gently press the activated carbon several times and shake the device so that the activated carbon is completely settled.
Need help?
Do you have a question about the 420 Purifier and is the answer not in the manual?
Questions and answers