Battery Watering Technologies NTHANDP Instruction Manual

T: 336-714-0448
F: 336-714-0449
G: 877-522-5431
www.batterywatering.com
NTHANDP_INSEF_0316
• Always wear personal protective equipment (goggles, gloves, etc.) to
protect yourself from sulfuric acid.
• Only water after charging.
• Do not store hand pump in battery compartment
• Read instructions in entirety before beginning the installation.
Operation Instructions:
1. Fully charge the batteries. This must be done
before water is added to the batteries to avoid
electrolyte loss.
2. Insert the pump assembly end into a just of
distilled water.
3. Remove the dust cap from the watering system
fill tube. Connect it to the manual pump
connector by inserting it into the quick connect.
4. Squeeze the bulb on the manual pump to begin
filling the battery cells with water. When the
bulb becomes hard and the valve indicator eyes
have risen, all of the cells are full.
5. Disconnect the manual pump connector from
the watering system and replace the dust cap.
NEVER LEAVE THE WATERING SYSTEM
CONNECTED TO THE MANUAL PUMP OR ANY
OTHER FILLING DEVICE.
Instruction Manual for Part # NTHANDP
Manual Pump