Onkyo P-3000R Instruction Manual page 11

Getting to Know the Preamplifier
~
+ +
+
~
ONKYO
<!}ON/STANOBY
0
'"'
0~~ ~
0
±±
1 I
10 11 1 13
The page numbers in parentheses show where you can find the main explanation for each item.
CD
ON/STANDBY button(-+ 25)
Sets the preamplifier to On or Standby.
®
Standby LED (-+ 25)
Lights when the preamplifier is in Standby mode.
@ Multi jog dial (-+ 29)
Selects the input sources in sequence. The input
sources are "CD", "LINE 1", "LINE 2", "LINE 3",
"COAXl", "COAX2", "OPTl", "OPT2",
"AES/EBU", "USB"*, "PHONO".
It is also used for various settings.
• You can select USB input only when the USB connector is
connected.
@ Remote control sensor (-+ 1 0)
The sensor receives control signals from the remote
controller.
@ Display (-+ 12)
See "Display".
@
Display Off LED (-+ 28)
Lights when the display is turned off.
Before entering standby mode with the ASb function,
the Display Off LED flashes 30 seconds before the
ASb function starts running.
(!)
Volume controller(-+ 26)
You can set the volume.
@
Direct LED (-+ 28)
Lights when the preamplifier is in Direct mode.
®
DIRECT button(-+ 28)
Selects the Direct mode. Pressing this button again
cancels the Direct mode.
@ POWER switch(-+ 25)
This is the main power switch. When set to the OFF
position (.a), the preamplifier is completely
shutdown. It must be set to the ON position(.-.) to set
the preamplifier to On or Standby.
@ MODE button(-+ 29)
Press this button to start the following settings:
"BASS", "TREBLE", "BALANCE", "BIAMP",
"HPLEVEL (headphone level)", "LINEOUT (or
RECOUT)", "ASb (Auto Standby)", "L2 OUT".
@ SRC (Sampling Rate Converter) button(-+ 33)
This button is used to convert the sampling rate of the
input digital signal: "BYPASS (no conversion)",
"FS x2", "FS x4".
Lj
Note
• The
USB
input does not support FS x4 (-+ 31).
@
DIGITAL button(-+ 26)
This button is used to turn the digital input source
display on or off.
@ PHONES jack(-+ 29, 34)
Stereo headphones with a standard plug can be
plugged into this jack.
En
11