Advertisement
Quick Links
1. Take off factory lens shade.
2. With camera upside down,
center the Zacuto Universal
Base Plate on the bottom of
camera and mount it to the
camera with captured ¼ 20
screw.
3. If you purchased a HVX200 lens ring, put the
white hoop around the lens.
4. Next, put the metal gear
around the white hoop.
5. Using the small enclosed Allen wrench, tighten the
metal gear onto the white hoop. This may take a few
times to adjust. A fairly loose fit is correct. Be
careful not to tighten too hard or you will put tension
on the focusing mechanism of the camera and
focusing will be rough.
UNVERSAL CAMERA SUPPORT INSTRUCTIONS
401 West Ontario, Suite 125 Chicago, IL 60610 support phone: 312-863-3453
Advertisement
Related Manuals for Zacuto VCT
Summary of Contents for Zacuto VCT
- Page 1 401 West Ontario, Suite 125 Chicago, IL 60610 support phone: 312-863-3453 1. Take off factory lens shade. 2. With camera upside down, center the Zacuto Universal Base Plate on the bottom of camera and mount it to the camera with captured ¼ 20 screw.
- Page 2 6. To allow for rods to slide back and forth, loosen 2 red rod levers on each side of the plate. Tighten the levers when you are finished adjusting rods. 7. Make sure the rods are out far enough so you can slide on the follow focus and matte box.
- Page 3 12. Slide matte box on the rods and tighten black lever on the matte box rod mount to lock into place. 13. Loosen 4 red rod tightening levers. 14. Slide rods so they are flush with the front of the matte box rod mount.
- Page 4 17b. To adjust vertically, loosen Allen screws on the front and back of the plate. This allows you to move the red plate the camera is resting on up and down. This may need to be done a few times to get the desired adjustment.
- Page 5 23. Next, screw on the monitor to the Noga arm while holding the arm and keeping a hand on the monitor so it doesn’t fall. 24. To adjust monitor into position, loosen the red levers of the Back Accessory Block and then keep a hand on the monitor while you loosen the big handle on the Noga arm.