Deco Lighting Small Gladetino Installation Manual

Small
Gladetino
Mounting Options
Before starting the installation and servicing, disconnect the power by turning off the circuit breaker. Turning the power off by using the light switch is not
sufficient to prevent electrical shock. All work should be done by a qualified electrician. This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the product and the hazards involved.
Pole Mount Arm (Mast Arm):
1. Align the Pole Mount Arm mounting holes with the (4) mounting holes on the rear side of the luminaire housing. (Fig. 1)
Fig. 1
2. Place the Pole Mount Arm against the housing, and route the Line, Neutral, and Ground wires through the small hole in the arm.
3. Fasten the arm to the housing using (4) included 1/4-20 bolts and the appropriate washers.(Fig. 2)
4. Loosen the (2) retaining bolts on the top of the arm so that the pole will not interfere with the bolts.
5. Connect the Line, Neutral, and Ground wires from the pole to the luminaire using the appropriate connectors.
6. Slide the pole completely into the arm and ensure that the luminaire is horizontal with the ground.
7. Tighten the (2) retaining bolts to fasten the luminaire to the pole. (Fig. 3)
Fig. 3
Deco Lighting practices a program of continuous product improvement, and as a result product specifications change frequently. We reserve the right to change
product specifications without notice. Contact Deco for the latest product information.
SAFETY PRECAUTION
Designed for 2-3/8" OD Pole
2917 Vail Ave., Commerce, CA 90040 • (800)613-DECO (3326) • info@getdeco.com www.getdeco.com
Fig. 2
Dimensional Drawings
1