Setup - Graco LazerVac Series Operation, Parts

Setup

1. Insert dust collection bags into Dust Collection
Tanks.
a. Remove Dust Collection Tank by pulling up on
the Engagement Lever and insert the collection
bag into the tank. Wrap the bag around the lip of
the tank and insert the Dust Bag Holder on top
of the bag. Reinsert the tank into the bottom of
the LazerVac. Lock the tank by pushing down
on the Engagement Lever.
b. If using a Cyclone separator, remove the
Separator Lid and insert the collection bag into
the tank. Insert the Dust Bag Holder on top of
the bag. Wrap the bag around the lip of the tank
and reinstall the Separator lid onto the tank.
3A5576D
2. Connect hoses.
If using a Cyclone separator:
• Connect one end of the Short Vacuum Hose to the
inlet of the LazerVac. Connect the other end of the
short hose to the outlet of the Cyclone separator.
• Connect one end of the Long Vacuum Hose to the
inlet of the Cyclone separator. Connect the other
end of the long hose to the vacuum hookup on the
GrindLazer.
If not using a Cyclone separator:
• Connect one end of the Long Vacuum Hose to the
inlet of the LazerVac. Connect the other end of the
long hose to the vacuum hookup on the GrindLazer.
NOTE: Use the Y-Connector (LazerVac 330 only) to
connect 2 hoses to the vacuum or separator, if desired.
Setup
7