Radionics D208RF Installation Instructions

Radionics"
About This Document
describes how to install, program,
This document
wire, and test the D208RF and D216RF Point
Expanders.
Introduction
The RF Point Expander allows you to use up to 8
(D208RF) or 16 (D216RF) ITI Learn Mode wire-
less devices with the Radionics D2212 panel.
Installation Guidelines
Observe the following guidelines when installing
the Expander:
Leave 10" above the Expander for the
l
antennas.
Avoid areas that are likely to expose the
l
Expander to moisture.
Avoid areas with excessive metal or electri-
l
cal wiring, including furnace and utility
rooms.
or-- If unavoidable, mount on metal with the
antenna extending above the metallic sur-
face (see Figure 1).
METAL
Figure 1. Mounting on Metal Surfacer
74-07476-000-A
RF Expander Installation Instructions
D208RF and D216RF Point
Expansion Modules
Installation Instructions
Document Number:
October 1995
Installing the Expander
CAUTION: You must be free of static elec-
tricity before handling circuit
boards. Touch a bare metal sur-
face or wear a grounding stmp
to discharge yourself.
To install the Expander:
1. Test the Expander at the desired location to
evaluate performance in the particular envi-
ronment.
2. Remove the Expander cover by pressing
down on the top center of the cover (see Fig
ure 2).
Figure 2. Removing the Expander' s Cover
3. Press down on the lower-right comer of the
bass until the latch releases the circuit board
(see Figure 3). Gently lift the circuit board by
the terminal block to remove it from the base.
Place the circuit board in the cover while you
mount the base.
4. Hold the base against the mounting surface
and mark the three mounting holes (see Fig-
ure 4). Remember to leave at least 10"
above the base for the antenna.
5. Remove the base and install the provided
anchors, lf studs are not present.
Page 1
466-l 020 Rev.A