La Crosse Technology 308-1425B Quick Setup Manual page 2

Get Started
Step 1: Insert the 5 volt AC cord (included) into the wall outlet then into
the forecast station.
Step 2: Insert the 3 new AAA Alkaline batteries (included) into the
forecast station. Observe the correct polarity.
Step 3: Insert the 2 new AA batteries (not included) into the
TX141TH-Bv2 outdoor sensor. Observe the correct polarity. The
red LED will flash during transmission.
Restart: If there is no outdoor temperature data after 3 minutes, unplug the AC
adapter and remove batteries from the forecast station & outdoor sensor for 15
minutes. Return to Step 1 above.
Set Time, Date, Temperature Unit
1. Hold the TIME SET button to enter time set mode.
2. Press the ▼ or ▲ buttons to adjust the values.
3. Press the TIME SET button to confirm adjustments and move to the
next item.
Time setting order:
1. WWVB time signal (On/Off)
2. Time Zone - 7 time zones
3. DST (Daylight Saving Time On/Off)
4. 12/24 hour time format
5. Hour
6. Minutes
7. Year
8. Month
9. Date
10. Fahrenheit/Celsius
Press the TIME SET button to exit, or wait 20 seconds without pressing
buttons to return to the normal time display.
Set Indoor and Outdoor Temperature Alerts
1. Hold the ALERTS button until the station beeps.
2. The temperature alert value will blink in set mode.
3. Press the ▼ or ▲ buttons to adjust the values.
4. Press the ALERTS button to confirm & move to the next
alert.
The temperature alert order:
1. Outdoor High, 2. Outdoor Low, 3. Indoor High, 4. Indoor Low
Press the ALERTS button to exit, or wait 20 seconds without pressing
buttons to return to normal time display.
Model: 308-1425B www.lacrossetechnology.com/support Page | 2