Advertisement
USAGE INSTRUCTIONS PLEASE READ PRIOR TO USE
CHARGING:
1. Please fully charge for four hours before first use
2. When charging, connect the DC end of the supplied 26V adapter to the battery's charging port
and plug AC side cable into wall outlet, then turn the power switch to the ON position to
charge.
3. The LED light flashes to indicate the battery level and indicates that it is charging.
4. When all LED stop flashing and remain lit, it indicates that the battery was fully charged.
5. Battery can be recharged at any time and at any battery level.
6. It is not recommended to fully deplete the battery to the red LED level.
7. This device average run-time is about 2 hours depending on speed level and pressure applied
during using.
OPERATING:
1. Turn the power switch on the bottom of the battery to the "ON" position to start the power.
Turn the power switch to the "OFF" position to turn off the power.
2. With the power on, short-press the gear button once to turn device on to level one, twice to
turn device to level two and three times to level three. Pressing the gear button again will turn
the device off. The blue LED lights would indicate the corresponding frequency level.
3. Massage desired body part at the desired speed applying pressure as needed.
4. With power off, you can change the massage head and pull it out by hand.
MAINTENANCE, CLEANING & STORAGE:
1. Use a slightly damp towel to clean device and a dry with a soft cloth.
2. For storage or travel, remove battery and store in supplied carton box.
2
Advertisement
