Industrial Scientific DSX Product Manual page 16

The remaining setup steps are shown below in detail. Those pertaining to the back of the docking station
(steps 2-18) can also be viewed as part of a completed docking station setup on page 18.
2 iGas Cable Retainer Setup
The docking station comes with three adhesive-
backed rubber pads and three cable ties. They are
used to prevent movement of the iGas cables
while they are connected to the docking station.
3 Network connection
PC connection
For DSXi units and iNet Accounts, a network
connection is required for setup and operation.
For Standalone Mode units, a PC connection is
recommended for setup. This allows you to access
and adjust the unit's settings through the on-board,
easy-to-use DSX Configurator. For example, you
can change the unit's date and time setting to
match your time zone so that bump test and
calibration records have accurate date-time
stamps. Once setup is completed, Standalone
Mode units can be disconnected from the
computer.
for DSXi units and iNet Accounts
for Standalone Mode units
Plug the cable into the
Network (or PC for
Standalone Mode orders).
12
Install the adhesive-
backed rubber pads into
the recessed areas of the
cable retainer.
─
Connect the other end to
the docking station's LAN
port.