Lind Equipment L61 Installation Instructions And Repair Parts List

Lind Equipment L61
INSTALLATION INSTRUCTIONS AND REPAIR PARTS LIST FOR
The L61 is designed for wall mounting and requires a flat vertical surface 5" wide and 7" high. If a large number of fixtures are to be
installed, we suggest removing the support bracket from one fixture for use as a template to locate mounting holes. Four 3/8" bolts
are required for mounting.
For the most efficient operation, we suggest mounting the fixture so that the light head, in a level position, can be placed into the top
corner of the lowest trailer utilizing the loading location. It should also be mounted as close to the door or opening edge as is practical.
For safety, the wall bracket should be mounted high enough to be out of the way of pedestrian and equipment traffic. Do not mount in
a manner that will allow the wall arm to be trapped under an overhead door as it is closing. The fixture should be mounted where it
will not be directly exposed to the elements. Recommended mounting height is 78" or higher.
For accessibility, note the location of the switch before mounting.
WI RI NG
Install the male plug from the arm assembly into the nearest
120VAC supply outlet. A rocker-type switch is built into the arm
to allow the light source to be switched on and off without
unplugging the unit.
C AU TI ON
All wiring should be done by licensed electricians in
accordance with local codes, state codes, as well as NEC
(National Electric Code) standards. Improper installation or
use may result in serious injury.
L61
MOU N T I N G
Install fixture according to "Mounting" instructions above.
Position the fixture with the arm in a straight line. Place one
hand on the light head and the other hand on the flexible arm.
(Please reference the Installing and Aiming sheet also included
in the packaging.)
For optimal performance and durability, the fixture is designed to
be positioned in one long continuous curve.
• Do not overbend or kink the flexible arm
• Do not attempt to lubricate the flexible arm
• Do not force sharp bends at either endpoint
• Do not fold flexible arm back to rest light head on
reinforced arm as this will damage the flexible arm
R E PA IR PA R TS
ITEM
90B Centurian Drive • Markham, Ontario L3R 8C4 Canada • Tel: 905-475-5086
A IM IN G
DESCRIPTION
1 LED ASSEMBLY
2 FLEXIBLE ARM
3 ROCKER SWITCH
4 DRIVER
5 SUPPLY CORD
www.lindequipment.net
PART NO.
L61-P1
L61-P2
L61-P3
L61-P4
L61-P5