Summary of Contents for S.R.Smith Color Light Streams Large Laminar
- Page 1 ™ Color Light Streams Large Laminar Installation Manual (CLSLL) 4008814 Input Power: 12V AC Total Power: ETL listed for installations within 5 ft. (1.5M) of outer edge of water www.srsmith.com 79-15152-00 Rev E2 9.14 Page 1 of 10...
- Page 2 (not included). 4. S.R. Smith Color Light Streams Large Laminar flow fountains can be placed in most any location from concrete decks, raised bond beams or even softscapes. Be sure that the distance from the interior pool wall to the laminar flow fountain is no further than 5’.
- Page 3 5. Each fountain requires a 1” (see table on page 5 for pipe size progression) PVC water supply that will be glued to the supplied reducer that connects the PVC flex inlet hose. 6. Each laminar may also have an individual, optional gate valve installed for minor flow adjustments.
- Page 4 7. Install 1” PVC pipe to the drain line connection. IT IS IMPERATIVE THAT ALL LAMINAR FLOW FOUNTAINS HAVE PROPER DRAINAGE AND ARE NOT ALLOWED TO FLOOD. Failure to provide adequate drainage may prevent proper operation and void warranty. 8. Install ¾” PVC conduit for 12VAC cable run to either side of the deck box. 9.
- Page 5 ADJUSTING WATER FLOW The laminar arc is determined by two factors: GPM water flow and angle of laminar. Set the angle of the laminar flow by using the two adjustment knobs on the inside the deck box on either side of the laminar. Adjust your distance by opening or closing each respective gate valve until the desired distance is achieved.
- Page 6 Advanced control requires iStar Controller - see operation manual for further instructions When connected to an approved, 12VAC, Class 2 power supply - The S.R.Smith CLS-2is LED color changing light source uses simple ‘off / on’ power switching to control the basic, pre-defined color modes with memory function.
- Page 7 IMPORTANT NOTES AND REMINDERS Minimize the number of plumbing fittings in the water run to cut down flow restrictions and water turbulence. Laminar flow fountains are susceptible to wind conditions and the higher the angle of your fountain the more they may be effected. If your area has regular amounts of high winds you may consider moving the fountains closer to the pool edge and decreasing the arc length of the fountain.
-
Page 8: Periodic Maintenance
Winterization is recommended in areas with freezing conditions. Winterization steps: 1. Remove LED light source from jet body by carefully unscrewing it from the threaded adaptor on jet body. Carefully place in a plastic bag and seal. Leaving it inside the deck box in an elevated position will help in case of flooding as it is not to be submerged. - Page 9 www.srsmith.com 79-15152-00 Rev E2 9.14 Page 9 of 10...
- Page 10 Lighted Laminar Light Enhancement Device In order to achieve maximum light output, the Light Enhancement Device will need to be adjusted. Adjustment of the “scratcher” or Light Enhancement Device will increase the light output of the laminar flow stream and also will allow you to create water effects such as “pulsing”...
Need help?
Do you have a question about the Color Light Streams Large Laminar and is the answer not in the manual?
Questions and answers