Advertisement
Table of Contents
PLEASE READ AND FOLLOW THIS INSTRUCTION BEFORE YOU USE AME International
LOCK NUT CYLINDERS.
Carefully inspect all components for shipping damage, if shipping damage is found. Please notify
carrier at once. The carrier is responsible for any damage resulting from shipment.
1. SAFETY
To avoid personal injury or property damage, please follow all safety precautions.
AME International cannot be responsible for injury or damage resulting from unsafe
and incorrect products use or system operation, or lack of maintenance.
DANGER is only used when your action or lack of action may cause serious injury or even death.
WARNING indicates a potential danger that requires correct action to avoid personal injury.
IMPORTANT indicates correct action to prevent damage or equipment failure.
DANGER
The hydraulic equipment operator must be a qualified operator must have correct training
and work experience with hydraulic equipment. Lack of knowledge in any of these areas can
lead to equipment damage or personal injury.
Carefully inspect cylinder, coupler, hose and hand pump before using hydraulic equipment, if
you find any damage, please contact with your nearest Authorized AME International
Service Center or Sales office. Any damage can cause personal injury when you use the
cylinder.
To avoid personal injury, please do not modify or weld hydraulic equipment without approval
of AME International.
Please never lift a more than the rated capacity of the cylinder, overloading causes
equipment failure and serious personal injury.
The cylinder is a load lifting device, not a load holding device. After the load has been raised
or lowered, it must always be held mechanically, never work under a load supported by a
hydraulic unit.
Keep hands and feet away from cylinder and workplace during operation to avoid personal
injury.
NEVER put unbalanced or off-center loads on cylinders. The incorrect load can result in
equipment failure and serious personal injury.
WARNING
Please wear safety glasses, helmet and other necessary personal protective equipment
when operating hydraulic equipment.
Use cylinder to lift load should have solid lifting surface for correct support. Please select
AME INTERNATIONAL
AME International Operating Manual for 100 Ton Aluminum
Cylinder with Locking Collar
Part Number 13155
1
www.ameintl.net
Advertisement
Table of Contents
Summary of Contents for AME Intl. 13155
- Page 1 AME International Operating Manual for 100 Ton Aluminum Cylinder with Locking Collar Part Number 13155 PLEASE READ AND FOLLOW THIS INSTRUCTION BEFORE YOU USE AME International LOCK NUT CYLINDERS. Carefully inspect all components for shipping damage, if shipping damage is found. Please notify carrier at once.
- Page 2 2. DESCRIPTION 13155 Aluminum Lock Nut Cylinders are Single-acting, low weight and spring return with a stop ring for stroke restriction. 13155 cylinders are provided with a fully threaded piston rod and a safety lock nut for positive load holding operations.
- Page 3 3. CONNECTION Before use cylinder, please visually check all units, to make sure there are no damage on cylinder, port threads, coupler and hose. No oil leaking and shortage of parts. If you find any problem please stop using your equipment and contact with your nearest authorized AME International Service Center or Sales office.
- Page 4 Always keep cylinder clean, use dust cap to protect coupler. After finish work, Cylinder must be fully retracted, cleaned and stored in ventilation, moist-proof, corrosion-proof place. 7. TROUBLE-SHOOTING WARNING: AME International Cylinders should be repaired only by a qualified operator or authorized AME International Service Center.
- Page 5 1. 0pen release valve 1. Pump release valve closed 2.Tightening the couplers 2. Couplers are not fully tightened Cylinder will 3. Drain hydraulic oil to correct level 3. Pump reservoir is full retract or Retracts 4. Clean or change hose 4.
Need help?
Do you have a question about the 13155 and is the answer not in the manual?
Questions and answers