Table of Contents
Advertisement
4
Side Burner Electrode Check
This test will ensure that the Spark Electrode
Tips are properly positioned so your Side
Burner lights easily and properly.
Be sure that both Control Knobs are set to
"OFF" and open the Side Burner Lid.
Press the Ignitor Cap. You should hear a
"clicking" sound. Your assistant should see
a blue spark within each Electrode Tip. If a
spark is present the Electrode Tips are
properly positioned.
If no spark is seen, the Spark Gap needs
to be adjusted as follows:
•
If the gap between the Spark Electrode Tip
and Burner Port is more than 3/16" use
needle nose pliers to gently squeeze the
Spark Electrode Tip to narrow gap.
•
Recheck the Electrode again, if no "clicking"
sound is heard:
-
AA Battery may be installed backwards.
-
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box
found behind the Control Panel and recon-
nect any loose wires.
Burner Port
WARNING
!
Failure to remove Side Burner Lid during the lighting
procedures could result in a fire or explosion that
could cause serious bodily injury, death, or property
damage.
3/16" Spark Gap
Spark
Electrode Tip
Install Cooking Components
5
Final Side Burner Assembly
!
When you have finished assembling your side
burner, be sure that all screws are tightened
for safe operation of your side burner.
Before each use of the side burner, make sure
the Grease Tray is fully seated under the Side
Burner Bowl.
CAUTION:
inspect the Grease Tray and inside of the Side
Burner Bowl to be sure there is no excessive
grease and debris buildup. Clean the Grease
Tray and inside of the Side Burner Bowl fre-
quently to eliminate grease/debris build-up and
to prevent grease fires.
9
Position the Pot Support over the Burners.
Place the Side Burner Lid over the Pot
Support.
Pot Support
Step
Before each use of your Side Burner,
Lid
Advertisement
Table of Contents
