Page 2
Support plate assembly G Finished assembly...
Page 3
12 x 60mm Screw 1 x Allen Key 10 x Connector Pin 4 x Support Plate Note: Some hardware retained from cot. 2 x Support Pin 10 x Locking Cam 20 x 25 Screw...
Page 8
Step 1 Select Side Rail, slide onto Step 1 Lay Foot panel on the ground screw Support Pin. holes facing up. Use screw driver to insert 4 x Connecting Pins as per Step 2 Insert 3 x Screws into Lower diagram.
Page 10
Support plate assembly Step 1 Select an L-shaped support plate and five screws. Step 2 Install a support plate onto one the corners where the leg rails meet the end panels as per diagram. Step 3 Using a screwdriver install the five screws into the pre-drilled holes securing the base plate to both the end panel and leg rails.