V
L
E N T U R E
I G H T I N G ' S
STOP
Before You Begin
Read These Instructions Completely and Carefully
Upgrade Instructions: Knuckle Mount
STEP 1: Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or
maintenance.
STEP 2: Remove the existing luminaire. Dispose of the lamp(s) and ballast(s) per local requirements.
STEP 3: Wrap teflon tape around the knuckle mount nipple (A).
STEP 4: Secure the fixture to 1/2" NPS hole, junction box, or landscape post.
STEP 5: Plug any unsued holes and seal thread with silicone.
STEP 6: Adjust the knuckle to aim the fixture where light is desired. (B)
STEP 7: Connect the fixture input leads (C) to the supply wire leads.
(C)
Wiring Diagram - Fixture Without Photocell
(+) LINE
(-) COMMON
GROUND
(C)
Wiring Diagram - Fixture With Photocell
(+) LINE
(-) COMMON
GROUND
STEP 8: Close the wiring enclosure.
NOTE: Take note NOT to pinch any wires when closing the fixture.
STEP 9: Power can now be restored to the fixture.
(877) 281-1233
Fax: (877) 294-2829
2451 Enterprise Parkway East
Twinsburg, Ohio 44087 USA
E-mail: venture@adlt.com
VentureLighting.com
© 2016 Venture Lighting International • Venture Lighting is a registered trademarks of Venture Lighting International.
L E D R
O U N D B A C K
BLACK
WHITE
LIGHT
FIXTURE
GREEN
BLACK
RED
BLACK
WHITE
WHITE
GREEN
F
L O O D
LIGHT
FIXTURE
U
M
SER
ANUAL
B
A
AV0003-A