Motor Lubrication; Use And Care - Viking VEV900 Instructions Manual

INSTALL THE ROUGH-IN PLATE
1. Run 10" round steel ductwork, from exterior blower
to the installation location. For best performance,
use the straightest possible duct run and the few-
est number of elbows. Tape all joints.
2. Run 120 VAC electrical power cable from service
panel and from remote blower to installation loca-
tion.
3. Remove wiring box cover. Remove knockouts
from the wiring box. Feed 6" of power cable through
openings and attach cables to wiring box with
appropriate connectors.
GREEN
EXTERIOR WHITE
BLOWER
BLACK
BLACK
WHITE
ROUGH-IN PLATE LEAD
4. Wire black to black, white to white, and green or
bare wire beneath green ground screw. Replace
wiring box cover.
5. Attach rough-in plate to the studs at the inside top
of hood with (4) #10-24 nuts provided.
6. Connect ductwork to rough-in plate and tape joint.
7. Turn on power and check blower operation.
VIKING RANGE CORPORATION
GREENWOOD, MISSISSIPPI 38930 USA
WIRING BOX
GREEN
LINE IN
WHITE
120 VAC
BLACK
60 HZ
10 A MAX.
BLACK
WHITE
GREEN
ROUGH-IN PLATE LEAD
10" DAMPER
MOUNTS INSIDE
DUCTWORK AT
LEAST 3" ABOVE
CANOPY OUTLET
10" ROUND
DUCT
HOUSE
WIRING
WIRE
BOX
POWER
COVER
CABLE

USE AND CARE

Disconnect electrical power supply and lock out
service panel before cleaning or servicing this unit.
CLEANING
Remove cover and carefully vacuum blower and
inside of housing. Be careful not to bend or otherwise
damage blower wheel.

MOTOR LUBRICATION

The motor is permanently lubricated. Do not oil or
disassemble motor.
4
99043131E