JABSCO CENTRI PUPPY 18510-000 Series Manual

"CENTRI PUPPY"
Bronze Centrifugal DC Motor/Pump Unit
With Lip Seal
FEATURES
Body & Impellor Bronze
Seal Lip type, Viton
Port Size 3/4" NPT Internal
Motor Permanent Magnet, Fully Enclosed
Ignition Protected
Shaft Stainless Steel
Weight 5 lb, (2,3 kg) approx.
Motor meets USCG Electrical Standards (Title 33,
Chapter I, Part 183; Subpart I) for IGNITION PROTEC-
TION on gasoline powered vessels.
Viton is a registered trademark of I.E. DuPont Co.
WARNING
!
Explosion hazard. Do not pump
gasoline, solvents, thinners or other
flammable liquids. To do so can cause
an explosion resulting in injury or death.
WARNING
Explosion hazard. Do not operate with
!
rivets removed from motor case.
Explosion resulting in personal injury,
death or property damage can occur.
Case openings must be sealed to avoid
explosion and maintain ignition
protected rating.
APPLICATION
Suited for many general pumping applications where a
flooded intake condition exists. This pump is NOT
SELF_PRIMING. Typical uses include livewell filling and
circulation, deisel fuel transfer (NOT GASOLINE), and
other applications not requiring a self-priming pump.
®
Model 18510-000X
VARIATION AVAILABLE
Model
18510-0000
18510-0001
PERFORMANCE (Nominal 12 Vdc System)
Amps Ft. of Water
8
6.7
5.4
4.5
INSTALLATION
The pump must be mounted in a dry location – the motor is
not waterproof and must not be submerged. The unit can be
mounted in any desired position. It is best to mount so that
water dripping from loose port connections will not wet the
motor. The pump head may be mounted vertically on a thru-
hull and seacock for applications requiring overboard water
to be pumped aboard. A seacock must be used between the
hull inlet fitting and pump on below-waterline installations.
Description
12Vdc
24Vdc
GPM
2 20
6 14.5
10 7.5
12.5 Shutoff