Page 3
persons with reduced For your safety physical, sensory or mental abilities or lacking experience and / or knowledge, only if these persons are supervised or have been instructed how to use the appliance These operating safely and have instructions contain understood the hazards important safety which could arise from...
Page 4
If the electric supply cord is at 30mA or less will provide extra protection against the damaged it should only be possibility of electric shock. replaced by a service A qualified electrician will engineer appointed by the be able to advise you. manufacturer or distributor.
Page 5
Safety instructions when operating the appliance CAUTION WARNING To avoid the risk of personal injury or damage to the Do not use the appliance always follow the appliance near bath instructions for installation, tubs, showers, use and maintenance. basins or other vessels containing ...
Page 6
Do not cover the air intake near water sources, even when the appliance is or air outlet during use. switched off. Do not place the appliance CAUTION or its supply cord on hot surfaces, e.g. cooker, or To avoid the risk of personal near naked flames.
Page 7
Protection There is a risk of electric category: class II shock if the appliance comes into contact with water. CE compliance: The appliance Please observe the following complies with EU Directives EMC 2004/108/EC and Low Voltage safety instructions: 2006/95/EC. Protect the appliance from ts of damp.
Page 8
The voltage of the power use for any other purpose. Warranty is void for damage source must be the same or failure caused by as that specified on the negligence or misuse. rating plate. The hairdryer is not Connecting the mains intended for professional supply cord use or use in public areas...
Page 9
VDE 0100-701. In the UK washbasin, a bath tub or inside a shower cubicle. the appliance may not be installed in the bathroom. Removing the cover Fig. 1 – 3 Loosen and remove the screw on the underside of the wall holder (see Fig.
Page 10
opening “X1“ prior to Comb your hair thoroughly. assembly (see Fig. 4) and connect it to a fused spur. Do not use hairspray or For further instructions other flammable hair care please refer to the earlier products. section “Connecting the mains supply cord”.
Page 11
to reduce the temperature To avoid the risk of electric according to the table below. shock from live parts please follow these safety instructions. Switch settings Before cleaning, disconnect the appliance Slow fan speed, 800 watts from the mains. 1 + COOL = Slow fan speed, 230 watts Fast fan speed, 1600 watts 2 + COOL = Fast fan speed, 460 watts...
Page 12
WEE/EJ0060TU the environment. Guarantee Disposal In addition to your statutory rights, Aslotel guarantee the appliance to be free from This symbol on the manufacturing and appliance, operating component defects for a instructions or packaging...
Need help?
Do you have a question about the 5516C.STA2 and is the answer not in the manual?
Questions and answers