Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bogen TMA812
Summary of Contents for Bogen TMA812
- Page 1 TMA812 Tilt Mount Adapter for NEAR A8 and A12 Loudspeakers Installation Instruction Manual 50 Spring Street, Ramsey, NJ 07446 USA Tel. 201-934-8500 • Fax: 201-934-9832 www.bogen.com Specifications subject to change. © Copyright 2008 Bogen Communications, Inc. 54-2187-01B 0812...
- Page 2 TMA812 - Tilt Mount Adapter Components STATIONARY MOUNTING BRACKET (4) MOUNTING CHAIN HOOKS (4) #10 AXLE/ADJUST SCREWS NYLON TIE 8 FT. SAFETY CABLE (2) POLE ADAPTERS (4) #6 POLE (4) #6 MOUNTING ADAPTER SCREWS BRACKET SCREWS (4) MOUNTING CHAIN HOOK WING NUTS...
- Page 3 WALL MOUNTING: Attaching Stationary Mounting Bracket to a Wall or other Flat Surface A) Using proper anchors* (not supplied), attach STATIONARY MOUNTING BRACKET to wall or flat surface. B) Skip ahead to Section 3 to continue with Speaker Adjustable Mounting Attachment Installation.
- Page 4 Attaching the Mounting Bracket Assembly to a Pole A) Thread NYLON TIE thru Tie Slots and around pole to TEMPORARILY hold the Mounting Bracket Assembly in place on pole. B) Apply a bead of THREAD LOCKING COMPOUND onto each Hook. Insert (4) MOUNTING CHAIN HOOKS and attached WING NUTS through...
- Page 5 Attach A8/A12 Speaker and Speaker Mounting Bracket to the Adjustable Mounting Bracket A) Attach ADJUSTABLE MOUNTING BRACKET to the A-Series SPEAKER MOUNTING BRACKET by using 4 (#6) Mounting Screws to create the SPEAKER MOUNTING ASSEMBLY. Apply THREAD LOCKING COMPOUND on each of the #6 screws. B) Adhere the 2 Self-Adhesive Rubber Disks to the Speaker Cabinet as shown below.
- Page 6 Attach Speaker Mounting Assembly to Stationary Mounting Bracket A) Place Speaker Mounting Assembly on the Stationary Mounting Assembly by putting the FRONT TABS of Speaker Assembly into the two FRONT CATCH slots of the Mounting Assembly (see INSET 1). B) With both Front Tabs hooked securely into both Front Catch slots, gently rotate Speaker Assembly back until both REAR TABS “snap”...
- Page 7 Speaker Assembly Angle Adjustment and Locking Procedure A) Add a drop of THREAD LOCKING COMPOUND to the 2 (#10) AXLE SCREWS and loosely insert them in both sides of Stationary Mounting Bracket and into the Speaker Assembly Bracket. This will provide safe retention of Speaker Assembly. B) Pinch inward both sides of the ANGLE ADJUSTMENT WINGS on the Mounting Bracket to rotate the Speaker Assembly to desired angle.
- Page 8 Speaker Safety Cable and Tether Link Attachment Installation A) Find the SAFETY ATTACHMENT POINT located on the rear of the A8/A12 Speaker. Using the (1/4”- 20 x 1/2”) HEX SOCKET SAFETY BOLT and the LOCK WASHER, secure the SAFETY TETHER LINK into the Safety Attachment Point, vertically, as shown.
Need help?
Do you have a question about the TMA812 and is the answer not in the manual?
Questions and answers