Summary of Contents for Logic LEVCA
- Page 1 Intelligent Charging FOR LEVCA MODELS DESIGNED TO CHARGE LI-ION / LIPO TWO-WAY RADIO BATTERIES User Manual...
- Page 2 12V - 24V source in a vehicle, trailer, or train. LEVCA models are radio specific and provide a precision fit with the battery. The model you have purchased is chemistry specific and will charge Li-Ion or LiPo batteries only.
-
Page 3: Table Of Contents
Table of Contents Topic Page Important & Caution Features Installation Charging A Battery Status LED Summary Battery Fault Conditions Specifications Warranty... -
Page 4: Important & Caution
1. Read all Caution statements below and this User Manual before attempting to install the LEVCA or charge a battery. 2. Check to make sure the LEVCA model is compatible with your radio battery and battery chemistry before installing. 3. Always charge new batteries completely before initial use. Recycle batteries when they can no longer be used. - Page 5 4. Make sure contacts on the radio holder and battery are clean. Do not allow wire or metal objects to touch the contacts. 5. Do not open or make any modifications to the LEVCA. Use only the DC power cable supplied.
-
Page 6: Features
LEVCA Features... - Page 7 3. Connection point for DC power cable. 4. Alpha contact™ for reliable battery charging. 5. Status LED (orange, red, green). 6. Hook for connecting tie-down strap. 7. Tie-down strap. 8. Screws and spacers for fastening LEVCA to vehicle. 9. DC power cable with locking connector plug.
-
Page 8: Installation
Before installing the LEVCA, confirm that the model is compatible with the radio battery you want to charge and the battery’s chemistry. 1. Select an area in the vehicle to mount the charger. The LEVCA’s compact size allows it to be installed in areas where other in-vehicle chargers will not fit. - Page 9 Installation (continued) 4. Use the 4 screws provided to fasten the LEVCA to the dash or wall of your vehicle. Place a rubber spacers over each screw on the back side of the charger to help stabilize the unit. 5. The tie down strap is properly sized to secure the radio in the charger. Place the elastic cord over the top of the radio and attach the plastic clip to the retaining hook.
-
Page 10: Charging A Battery
A battery may be charged while on or off the radio. Always use the tie-down strap to secure the radio or battery before your vehicle is driven. 1. After the LEVCA is installed, switch vehicle power on and place a battery in the charger. The status LED will illuminate ORANGE briefly, then RED contin- uously to indicate normal charging. - Page 11 GREEN and flash. The charge status LED will illuminate GREEN with no flashing when the battery is fully charged. 4. A fully charged battery may be left in the LEVCA and a full charge will be maintained. This maintenance feature will not damage the battery.
-
Page 12: Status Led Summary
Status LED Summary LED Color Status Solid ORANGE Diagnostic stage - LED illuminates briefly when battery is inserted. Flashing ORANGE Battery cannot be charged because: (1) temperature is below 0°C (32°F) or above 45°C (113°F), or (2) chemistry is not compatible with charger. Solid RED Normal battery charging. -
Page 13: Battery Fault Conditions
Fault Conditions Flash Pattern (RED) Fault Type 1 Time Charging is complete, but battery is under charged. Battery voltage is below the minimum level required. 2 Times Battery contact is ‘open’ and current is not passing through the positive and negative terminals of the battery. -
Page 14: Specifications
Specifications Compatible Battery Chemistries Li-Ion / LiPo (7.2V-10.8V) Operating Temperature 0ºC - 45ºC / 32ºC - 113ºC Charger Input 10V - 30V DC @ 1.0A (minimum) Charge Rate Up to 1000 mA DC Power Cable 16AWG / 3A in-line fuse / 3.0m (9.8’) Charger Contacts High impact and vibration tolerant alpha contact™... -
Page 15: Warranty
Warranty & Service During Warranty Power Products Unlimited, Inc. (PPU) warrants this product to be free from defects in workmanship and materials for three years from date of purchase by the end user. This warranty applies to the original purchaser and is void if the product has been altered, misused, damaged, neglected, or if repair is required because of normal wear and tear. - Page 16 Vehicle power adapter to connect LEVCA to a 12V or 24V outlet. Allows LEVCA to be used “plug-and-play.” ©2016 Power Products Unlimited, Inc. Power Products, Logic, and Charging Solutions For Professionals are trademarks of Power Products Unlimited, Inc. All rights reserved.