Advertisement
INSTALLATION INSTRUCTIONS
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual before
you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
Prior to installation, unpack the floor riser support assembly and inspect it for damage. If the product is
damaged, please contact Kallista immediately at the phone number listed at the bottom of the page.
Shut off the main water supply.
Observe all local plumbing and building codes.
The installation of the riser support assembly should coincide with the installation of the floor risers.
To prevent damaging the tub, the floor riser support assembly should be mounted a minimum of 12" from the
floor.
Kallista reserves the right to make revisions in the design of plumbing products without notice, as specified in
the Price Book.
Pencil
Strap
Wrench
Thread the pipe holders onto the tee bracket.
Use the hex wrench to back the set screws out slightly,
so that the floor risers (not provided) can be inserted
without scratching them.
1085231-2-A
Page 1 of 3
THANK YOU FOR CHOOSING KALLISTA
BEFORE YOU BEGIN
TOOLS AND MATERIALS
Drill
Tape Measure
or Ruler
1. ASSEMBLE THE PIPE HOLDERS & TEE BRACKET
Floor Riser Support Assembly
Silicone
Hex
Wrench
Pipe Holder
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
P23010
Hacksaw
Phillips
Screwdrivers
Tee Bracket
Set Screw
Pipe Holder
Scale: 1/4" = 1"
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kallista P23010
Summary of Contents for Kallista P23010
- Page 1 To prevent damaging the tub, the floor riser support assembly should be mounted a minimum of 12” from the floor. Kallista reserves the right to make revisions in the design of plumbing products without notice, as specified in the Price Book.
- Page 2 Remove any burrs or sharp edges. Scale: 3/16” = 1” 1085231-2-A Questions? Problems? For additional assistance, please contact Kallista's Customer Page 2 of 3 Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
- Page 3 Mounting Plate screws. Self Tapping Screws Tighten the set screw in the tee bracket. Scale: 1/8” = 1” 1085231-2-A Questions? Problems? For additional assistance, please contact Kallista's Customer Page 3 of 3 Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Need help?
Do you have a question about the P23010 and is the answer not in the manual?
Questions and answers