Connecting Kerio Control Box Ng511 To The Network; Configuration Steps - GFI Kerio Control Box NG510 Quick Start Manual

To configure the appliance:
1. ​ C onnect the Internet port to the Internet (e.g.DSL or Cable modem) using an Ethernet
cable.
2. ​ C onnect the LAN port to the computer that will be used to configure the appliance (see the figures
above).
3. ​ T urn on the appliance.
Now you have two options:
- Add and manage the appliance through MyKerio. See
https://go.gfi.com/?pageid=ControlMyKerio​
- Access the Kerio Control Administration through a browser (see below):
1. Set the networking preferences for Ethernet on the connected computer to "Automatic DHCP
configuration". (You can change it later after the configuration is complete).
2. Renew the DHCP lease on the computer and confirm it has an IP address of 10.10.10.11
3. Open a web browser and connect to the Kerio Control Administration web interface using the following
URL:
https://10.10.10.1/admin​
4. Ignore the SSL certificate warnings and proceed to the configuration wizard.
5. Follow the instructions provided by the wizard and configure the appliance.
See ​
h ttps://go.gfi.com/?pageid=ControlActivationWizard​
For troubleshooting purposes, you can use the serial port to connect the console to the appliance. See
Screenshot 4: Connecting Kerio Control Box NG511 to the network
.
.
.