Attach Hanging Brackets to Sides using Euroscrews. (If using Power Drill, set torque to low setting.)
Step 3: Attach Sides and Verticals
b
Cam
Lock
(a) Attach Sides and Verticals to Bottom. (b) Lock Cams by turning clockwise until snug.
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
freedomRail Garage Assembly Instructions
Cubby GOBox
Right Side
Right Side
Vertical
#2 Phillips Driver
#2 Phillips
Screwdriver
a
a
Open
Vertical
Hammer
Right Side
Back Edge
Step 4: Attach Top
(a) Attach Top. (b) Lock Cams by turning clockwise until snug.
Over
Top and Bottom
Horizontal
Step 2: Install Connector Bolts
Top and Bottom
Smaller Holes for
Connector Bolts
Install (8) Connector Bolts into small holes on Top and Bottom Panels.
Summary of Contents for Organized Living freedomRail Cubby GOBox
Page 1
freedomRail Garage Assembly Instructions Cubby GOBox Contents of Package (20) Euroscrews Left Side Right Side Left Side Right Side (16) Connector Bolts Top and Bottom Hanging Brackets Nameplate Backing and Screws Vertical Horizontal (16) Vertical Backing Nails Tools Required #2 Phillips Driver Power Drill #2 Phillips Hammer...