Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Waves WRC-1
- Page 1 WRC-1 Advanced WIFI Stage Router User Guide...
- Page 2 About WRC-1 WRC-1 is an advanced Wi-Fi router designed specifically with the needs of live sound engineers in mind. It’s a perfect match with the Waves MyMon Personal Monitor Mixing app for mobile devices, as well as other remote- control mixing apps.
- Page 3 For best results, follow these guidelines: • Mount the WRC-1 near the top of the rack and away from any other gear that may use radio waves in the same 2.4 GHz or 5 GHz range. Note that rack-mount computers or laptops placed directly above the WRC-1 may cause wireless interference.
- Page 4 Cat 5e (or better) cable. 4. Connect any available WRC-1 LAN port (1) to the Ethernet port on the host computer. This must be the same port used by the MyMon /LV1 network, not the SoundGrid network. Use Cat 5e (or better) cable.
- Page 5 Set 5G Wi-Fi Password Using WRC-1 Management Software. 1. Disconnect the computer that you will use to configure WRC-1 from all connected networks and disable Wi-Fi. 2. Connect any available WRC-1 LAN port to a port on the computer, using Cat 5e cable.
- Page 6 7. Click Perform Reset next to “Factory Reset” and follow the prompts. ESET USING THE ESET WITCH IN REAR PANEL DIAGRAM 1. Make sure WRC-1 unit is ON. 2. Press and Hold the Reset Switch for six seconds. WRC-1 will restart in “Factory” state. WRC-1 Wi-Fi Router / User Guide...
- Page 7 Updating WRC-1 Firmware To update WRC-1 firmware, repeat steps 1-4 as above, and then: 5. Go to System Management on the left sidebar. 6. Click on the System Upgrade Tab 7. Click Upload the Upgrade, then browse and select the firmware file.
Need help?
Do you have a question about the WRC-1 and is the answer not in the manual?
Questions and answers