Advertisement
Quick Links
Stainless Steel Hopper Spreaders
PARTS LIST
13
7
Item
Part
Qty Description
1
99495
1
Strobe Light Bracket – PS
2
99496
1
Strobe Light Bracket – DS
3
78379
2
Strobe Light – LED
4
78381
1
Harness Assembly w/Relay & Fuse
Item 3
7
2
#6-32 x 5/8 Machine Screw SS
8
2
#6-32 Locknut SS
10
6
#10-32 x 1 Machine Screw SS
11
6
#10-32 Hex Locknut GB SS
12
8
#10 Flat Washer SS
ns = not shown
Strobe Light Kit
10
2
3
8
9
4
YEL
YEL
99494 Strobe Light Kit
78379 Strobe Light – LED
99103 Bolt Bag
A DIVISION OF DOUGLAS DYNAMICS, LLC
11
Item
Part
Qty Description
5
78378
1
6
78386
1
ns
99103
1
9
1
13
8
ns
6
G = Grade
August 1, 2020
Lit. No. 92945, Rev. 05
12
1
6
5
Harness Assembly – 56"
Harness Assembly – 72"
Bolt Bag
Strobe Light Gasket
Fir Tree Mount w/Cable Tie
Cable Tie – 15.35"
SS = Stainless Steel
99494
Advertisement
Summary of Contents for Douglas Dynamics DD 99494
- Page 1 #10-32 x 1 Machine Screw SS Fir Tree Mount w/Cable Tie #10-32 Hex Locknut GB SS Cable Tie – 15.35" #10 Flat Washer SS ns = not shown G = Grade SS = Stainless Steel A DIVISION OF DOUGLAS DYNAMICS, LLC...
-
Page 2: Installation Instructions
99494 INSTALLATION INSTRUCTIONS Install Brackets and Lights 1. Park the vehicle on a smooth, level, hard surface, WARNING such as concrete. Turn the vehicle ignition to the Do not exceed GVWR or GAWR ratings "OFF" position and remove the key. as found on the driver-side vehicle door cornerpost. - Page 3 99494 Install Harness, Relay, and Fuse Assembly Feed the electrical connector and leads from one of the LED strobe lights through the large hole in one of the brackets. Install the LED light If an accessory work light has been installed and gasket to the bracket using the supplied previously, the strobe light harness can be secured to #6 x 5/8"...
- Page 4 99494 3. The strobe light kit contains two harness 5. Mount the relay/fuse assembly to the relay/fuse assemblies: 56" and 72". Determine your harness assembly bracket by pushing the connector clip on routing and connect the appropriate harness to the back of the assembly into one of the holes in each strobe light.
-
Page 5: Electrical Connections
99494 Electrical Connections installations with multiple accessories, it may be necessary to notch the sides of the isolated stud block cover to accommodate all the wires. 1. Plug the relay/fuse harness 10-pin connector into the relay/fuse assembly. 4. Electric Spreaders: Connect the single-pin terminal on the relay/fuse assembly harness 2. -
Page 6: Strobe Light Operation
NOTE: The white wire is not used. Copyright © 2020 Douglas Dynamics, LLC. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, fi lm, or other distribution and storage media, without the written consent of the company. Authorization to photocopy items for internal or personal use by the company's outlets or spreader owner is granted.
Need help?
Do you have a question about the DD 99494 and is the answer not in the manual?
Questions and answers