TA Service Electrical office/work chair Instructions Manual

Instructions for TA electrical office/work chair

Characteristics

Office/work chair with high/low lift and electrical controlled centralbrake.

Use:

1. Help to get up

2. Side transfer

3. Work chair for varying heights

Important advantages

40 cm. Height variation – covers almost all needs

Centralbrake is always placed right

Lock of seat turning and rolling all at once

Lower primary height than other chairs with turningbase

All electrical control is placed by the armrest

Large seating area with extra sturdy padding

Extra wear resistance padding, non-flammable.

1. Primary height

Before taking the chair into use, decide what the need for height intervals is.

Use the normal height 42-82 cm, or choose between 37-77, 47-87 or 52-92 cm from the floor.

Loosen the screw on the lifting device, lift to the choosen primary height and fix the screw again.

The chair is fitted with a bottom stop for lowest primary height.

2. Seat depth

Adjust with the hand level under the seat right rear edge. If the level is loosened the seat can be moved forward by

pressing the body against the back rest or moved backward by pressing with the legs. The hand level can be turned

freely to the most appropriate position by pulling it.

WARNING!!! Height and depth must be limited as much as possible, to minimize the risk

the chair can tip over, when transferring to or out the chair.

WARNING!!! Before you sit or rise from the chair, when elevated, be sure two of the wheels

is turning forwards to obtain best stability in the chair.

3. Back height

Adjust with the hand screw on the backside of the back shield.

4. Armrest

Adjust width by loosening the umbraco screw on the tube on which the armrest is fitted. The lenght can be adjusted by

loosening the two bolts under the armrestpads.

5. Lift and brakes

The controlbox with buttons for lift and brakes is placed on the front edge of the armrest.

The brakes should be activated when lifting in connection with alightning or transferring.

6. Recharging

Table of Contents

Do you have a question about the Electrical office/work chair and is the answer not in the manual?

Page 1 Instructions for TA electrical office/work chair Characteristics Office/work chair with high/low lift and electrical controlled centralbrake. Use: 1. Help to get up 2. Side transfer 3. Work chair for varying heights Important advantages 40 cm. Height variation – covers almost all needs...
Page 2 The recharging plug is placed in the outlet on the side of the controlbox, where after the power is turned on to the recharger. The green charging lamp will be turned on during the recharging and turns off when fully charged. The batteries are maintenance free, but should be recharged 1-2 times a week.
Page 3 Agreement declaration In accordance to the directive for machinery 89/392/EEC with attachmant 2A. Producer: TA. Service A/S Orupgade 32 B Orup DK-4640 Faxe Denmark Tel. +45 56725777 Fax. +4556725776 Product name: TA Officechair ISO Group 180903 Serial no.: Production year: 2008 The above machinery declares hereby to be in accordance with the essential demands in accordance to the directive of machinery 89/392/EEC with attachment 2A, and EMC-directive 89/336/EØF on electromagnetic compatibility.