Related Manuals for Garrick JS950M
Summary of Contents for Garrick JS950M
- Page 1 Multi-function Sharpener Model: JS950M INSTRUCTION MANUAL New Zealand: Australia: R.R. Bramley & Co Ltd Garrick Herbert Pty Ltd...
-
Page 2: Safety General Instructions
Carry protective glasses to avoid ocular injuries. We recommend that you take appropriate measures for the protection of hearing if the sound pressure of 85 dB (A) is exceeded. WEAR A MASK Carry gloves to avoid skin combustion. Safety General Instructions Warning! When using electric tools, the following basic safety precautions should always be taken to reduce the risk of fire, electric shock and personal injury. -
Page 3: Specific Safety Instructions
dusty or if using in enclosed spaces. 10. Connect dust exaction equipment. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used, especially in confined areas. 11. Do not abuse the cord. Never carry the tool by its cord or yank it to disconnect it from the socket. -
Page 4: Additional Recommendations
- Make sure that the wheels are installed in compliance with the manufacturer’s instructions; - Make sure that the abrasive product is correctly mounted and clamped before use and use the tool off-load for 30 s in a safe position, stop it immediately if important vibrations are produced or if other defects are detected. -
Page 5: Install And Operation
INSTALL AND OPERATION 1. Set the sharpener in a stable position. 2. Connect the plug to a outlet. 3. Switch on the tool by setting the switch to “Ⅰ” position. 4. Allow the sharpener running a few minutes and then choose the right position according the tool to be sharpened. - Page 6 Slot on guide Drill holder Rib on the drill holder holder rib on the drill holder slot on should fit in the the guide. knob With the set the thickness of material to remove according to the scale (slight thickness to refresh the sharpening, large thickness for a highly damaged drill).
- Page 7 the positioning of the drill is thus obtained, then tighten the drill in the drill-holder. Clockwise rotate the grasp of drill-holder, the drill will be tightened. Open the positioning claws. Remove the drillholder from the guide. Check the tightening of the drill in the drill-holder.
- Page 8 To get a drill clearance (for drills exceed φ10mm): Insert the holder with drill into the sharpen hole. Remove the drill-holder from the hole and turn the holder 180°，reinsert, to get the other crest sharpened. rib on the holder should fit in the slot on the guide.
- Page 9 WARNING! This machine produces an electromagnetic field during operation. This field may under some circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal injury, we recommend persons with medical implants to consult their physician and the medical implant manufacturer before operating this machine.
- Page 12 New Zealand: R.R. Bramley & Co Ltd Mt Wellington, Auckland www.bramley.co.nz Australia: Garrick Herbert Pty Ltd Kirrawee, Sydney www.garrickherbert.com.au...
Need help?
Do you have a question about the JS950M and is the answer not in the manual?
Questions and answers