Dell Latitude 5300 2-in-1 Chrome Service Manual page 70

Steps
1. Peel the adhesive tape and disconnect the EMR sensor cable from the connector on the system board [1].
2. Peel the adhesive tape and disconnect the touch screen cable from the connector on the system board [2].
3. Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [3].
4. Lift the eDP cable bracket from the system board [4].
5. Disconnect the eDP cable from the system board [5].
6. Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface.
70 Komponentide eemaldamine ja paigaldamine